ledscom LC-EL-087-W Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
Drill a 35mm diameter and 30mm deep
mounting hole (4) to properly install the
fixture.
Guide the connecting cable (3) through the
installation opening (4) and place the lamp
(1) in the installation opening (4).
4. Connect the connection cable to a
power supply unit that has the matching
connector system (Figure 2) or an identical
luminaire. Screw the cap tightly to protect
the connection from water. When
connecting the cables, make sure that the
polarity is correct (notch in the connector).
Make sure that the screw cap is not in the
water.
5. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Ground recessed light (LC-EL-087-W) - Assembly instructions
Figure 1
1: Luminaire
2: Brackets
Figure 2
3: Connection line
4: Installation opening
10/2022