Descargar Imprimir esta página

BLS 2600 NEXT Manual De Instrucciones página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
limit of the battery set to guarantee a minimum
flow rate of 160 l/min and an operating duration
of 4 hours;
3. Do not use the BLS 2600next electric fan longer
than specified;
4. If breathing becomes more difficult (increased
inhalation effort) due to excessive clogging of the
filter, immediately leave the contaminated area
and replace the filter;
Action
LED status
Battery status
(charging)
Battery status
(in use)
ALARM
filter clogging
ALARM
block
ALLARM
no filter
AFTER USE
It is necessary to decontaminate the electric fan
before leaving the work area, according to the fol-
lowing procedure:
1. Electric fan and mask must be worn while re-
moving the protective clothing;
2. Make sure that the waterproof cover is properly
positioned;
3. Turn off the fan before entering the shower area;
4. When rinsing the mask, hose and fan unit, be
careful not to let the water into the unit, the filter
5. If the electric fan stops working, leave the work
area immediately because the lack of positive
pressure can reduce the protection level;
6. The acoustic alarm system signals insufficient
air flow situations;
7. The colored LED light signals the following in-
formation, according to the table below:
ELECTRIC FAN
Color
Signal
BLUE
Flashing
GREEN
Steady
RED
Steady
RED
Flashing
Flashing
(every 10")
YELLOW
Flashing
(every 3")
RED
Sequential
RED
Sequential
and the hose in order to avoid contamination that
is difficult to remove;
5. Remove the fan and mask and store them out-
side the shower cabin;
6. Proceed with the decontamination shower;
7. Clean the electric fan, the flexible hose and the
mask with a soft damp cloth, making sure not to
let the water into the hose and into the fan. Use a
brush to clean the recessed corners;
8. Allow the electric fan, hose and mask to dry in a
ventilated area, without using radiant heat;
11
Sound and
Flow
vibrations
>160 l/min
X
-
X
V
V
V
Exit the work area
V
X
V
V
Replace the filter
Exit the work area
V
X
and replace the filter
Exit the work area
and check the condi-
V
X
tion of the hose and
SWITCHING
Make sure that there
V
OFF
is no filter or mask
OPERATOR
Action
-
-
Recharge
and recharge
storage cap

Publicidad

loading

Productos relacionados para BLS 2600 NEXT