Descargar Imprimir esta página

Crosley Coda CR7017B Manual De Instrucciones página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

English
24. Power Jack
25. Line Out Jack
Initial Setup
Essential Setup
1. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Place the slip mat on top of the turntable platter.
4. Connect the speakers to the speaker jacks at the back of the unit.
5. Connect power adaptor to the Power Jack of the unit.
Note: Do not plug the power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Turntable Platter and Belt Setup
1. Place the platter through the turntable spindle, then rotate the platter until you
see the drive motor pulley through the window at the top right corner.
2. Carefully grab the drive belt and put it around the slot of motor pulley.
26. Speaker Jacks
27. Speakers
5

Publicidad

loading