Descargar Imprimir esta página

Zodiac Polaris WaterStarsWF Manual Del Propietário página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
Installation Instructions
Installing the Universal Wall Fitting
The WaterStarsWF
uses a universal wall fitting
(UWF) that fits into the 1-1/2" female threaded return
line. If an eyeball fitting is installed, remove the parts
as shown below and then install the UWF.
1-1/2" Return Line
Universal
Wall Fitting
Remove
Eyeball Fitting
Adjustable
1. Turn on the pool filtration pump and flush the
plumbing line. Turn off the pump.
2. Screw UWF into the return line, hand tighten.
3. Turn the quick disconnect end of the riser
clockwise into the UWF until secure.
Assembling the WaterStarsWF
1. Screw either the flower or morning glory fountain
head onto the threaded end of the riser.
2. The fountain head should be above water level
but below the top of the deck. To adjust the
height, loosen the riser and slide the 3/4" pipe
up or down.
3/4" Pipe
Riser
If the fountain head extends above the deck,
remove the head, push the pipe all the way down
and measure the excess pipe. The threaded
section should be just above water level. Cut
pipe from the bottom - do not cut threaded end -
leaving at least 3". Slide pipe back into place and
screw on fountain head.
Quick
Disconnect
Plug
Nut
3. Retighten the nut.
4. Turn on the pool pump.
Fountain Display Height Adjustments
The adjustable plug is used to change the height of
the fountain display. Loosen the plug to decrease the
height, tighten to increase it. The morning glory foun-
tain can be further adjusted by tightening or loosen-
ing the spreader.
Morning
Glory
Head
If there is too much water pressure, install the restric-
tor washer by snapping it into the Quick Disconnect.
Storage and Winterizing
To disconnect the WaterStarsWF, turn off the pool
pump, push the Quick Disconnect in and turn
counterclockwise.
Drain all water from the WaterStarsWF and store it in
a secure place, out of direct sunlight.
To winterize, remove the UWF from the pool by
pulling the Quick Disconnect away from the wall
while unscrewing the UWF. If necessary, a UWF
removal tool (part #10-102-00) is available.
Warranty
Thank you for choosing the Polaris WaterStarsWF
This product has been designed, manufactured
and checked with great care to ensure
complete satisfaction.
The guarantee period shall be one year (two years in
the UK) from the date of invoicing to the first user.
Spreader

Publicidad

loading