Publicidad
ENGLISH
Safety conditions:
1. Never add neutralizing fluid, deodorant to the clean water container.
2. Make sure you have enough clean water before use.
3. Do not lean on the cover when it is upright.
4. Empty and clean the waste bin regularly. At least every 5 days. More often in case of high temperature.
5. Avoid prolonged exposure to sunlight.
6. Avoid high temperatures (Above 60C)
7. Children should use the device under adult supervision.
Device description:
1. Flap 2. Board 3. Hinge 4. Flush valve 5. Water tank plug 6. Water tank
7. Hinges 8. Top seal 9. Drain valve 10. Bottom seal 11. Plug for waste container
12. Container for waste
Before first use:
1. Remove all packing materials such as film and cardboard from the machine.
2. Clean the inside and outside of the device with a damp, soft cloth.
3. If it is open, close the drain valve (9) by pressing the trigger.
4. Unhook the fastening clamps (7) on both sides of the device.
5. Pull up sharply to detach the seat (6) from the reservoir.
6. Unscrew the tank valve (11).
7. Pour water into the tank (12) and close the valve.
8. Thoroughly rinse the inside of the tank by shaking it vigorously.
9. Unscrew the valve (11) and pour out the contents.
10. Put the seat (6) on the reservoir (12) making sure that the outlet (8) from the seat (9) coincides exactly with the reservoir valve.
11. Open the drain valve (9) by pulling the draw lever.
!!WARNING!! A small amount of water may spray off the gaskets and valve. Therefore, opening the valve should be performed with the
seat cover closed.
12. Check that the trapdoor inside and the tank gasket make a tight connection. If not: Replace the gasket or use petroleum jelly and
spread it on the inside of the gasket to moisturize and seal it.
13. Press and pull the draw lever (9) slowly to check for leaks.
14. Open the cistern cock (5).
15. Pour clean water into the cistern. To test, pour in approx. 200 ml of water (1 glass).
!! WARNING !! Never pour any liquid other than clean water into the cistern, as this may damage the mechanism or seals.
16. Open the drain valve (9) by pulling the draw lever.
17. Pull out and push in the cistern levers slowly to check the obstruction and operation of the cistern channels. !! WARNING !! The water
is escaping from the cistern under significant pressure. Single drops may escape from the device when checked.
18. If all the points above went smoothly. The device is ready for use.
!! WARNING !! After not using the product for more than 3 months, repeat steps 2-18 again !! WARNING !!
Preparation for use:
1. Pull the trigger (9) and open the drain tank (12).
2. Open the hatch (1).
3. Pour in the neutralizing fluid, deodorant according to the recommendations of the fluid manufacturer.
4. Press the release lever (9) to close the drain tank.
5. Gently rock the device to distribute the neutralizing agent inside the container.
6. Open the flush valve (5) and add water. Leave at least 5 cm of space between the tap thread and the water surface. Do not flood the
container with clean water completely.
!! WARNING !! Never pour any liquid other than clean water into the cistern, as this may damage the mechanism or seals.
7. The device is ready for use.
Using the device.
1. Pull the trigger (9) and open the drain tank to equalize the pressure between the chambers.
2. Open the seat cover (1).
3. After use, close the seat flap (1).
4. Press the cistern lever (4) several times.
5. Press the release lever (9) and close the waste container.
3
Publicidad
