MPM MOP-33M Manual De Instrucciones página 13

Idiomas disponibles

USE OF THE SANDWICH/WAFFLE MAKER/GRILL

NOTE! When opening the cover, proceed carefully owing to hot damp from the area under the heating panels!

Depends on the product you want to prepare, place the sandwich/waffle/grilling plates in the

appliance.

1. Oil the heating plates with butter, margarine or other fat. Close the cover of the appliance ❸.

2. Make sure that the temperature control knob ❾ is set to 0. Plug the grill to a mains outlet.

The Power indicator light ❶ will be on. Set the desired temperature with ❾. The tempera-

ture control light ❷ will be on, and the grill will begin heating up. The temperature control

knob ❾ setting 0 means that the grill heating is off. Each next setting, 1, 2, 3, 4, and 5, indicate

the heating temperature rise in the ascending order.

3. Prepare the sandwiches, dough for waffles or products for grilling.

4. When the green indicator lamp ❷ will go off, open the cover by pulling the latch ❹ and put

the products on the heating plates. Gently close the cover and clamp with clip ❹.

5. When checking the condition of products in course of their roasting, open the cover carefully

owing to hot damp escaping from the both sides of the appliance! Adjust the temperature

with the thermostat knob according to the desired effect.

6. Open the cover and remove sandwiches/waffles/grilled products using wooden or plastic

spatula.

7. Before preparation of the next products, always close the cover in order to maintain required

temperature. The green caution lamp (thermostat) will go on and off in course of roasting

to indicate that required temperature is maintained.

8. When done grilling, set the temperature control knob ❾ to 0, unplug the grill from the

mains, and leave the grill to cool down completely.

NOTE! Do not use and metal and sharp knifes or forks, otherwise the damages of heating surfaces are possible!

CLEANING AND MAINTENANCE

1. Prior to commencing the cleaning (and after finishing the roasting), pull out the plug from

the plug socket and allow the appliance to cool completely.

2. Thoroughly wash the heating panels, clean the roaster edges using soft cloth or towel. For

ease of cleaning, the heating plates may be disassembled.

3. If complete removal of any food residuals from the surface of heating panels is problematic,

pour some edible onto dirty surface and try to clean after about 5 minutes. Your efforts will

be successful this time.

4. Wipe the external surface of the roaster using wet cloth.

ATTENTION! Do not immerse the appliance in water or any other liquids! Do not wipe the inside of the appliance

with acute, abrasive cloths or sponges, as this can damage the heating surfaces!

MOP-33M_instrukcja_v08.indd 13

12.04.2022 08:39:12