Ameda Platinum Instrucciones página 6

SET UP AND ASSEMBLY
Before Every Use
Always wash hands well with soap and water before handling the Ameda Platinum Breast Pump and
Ameda HygieniKit Milk Collection System.
IMPORTANT NOTE: ONLY USE THE AMEDA HYGIENIKIT MILK COLLECTION SYSTEM ON AMEDA ELECTRIC
BREAST PUMPS.
Prior to starting pump, assemble and connect the Ameda HygieniKit Milk Collection System, per included instruc-
tions. If the Ameda HygieniKit Milk Collection System is sterile, use as is. If not sterile, see the Ameda HygieniKit
Milk Collection System cleaning instructions.
Ameda HygieniKit Milk Collection System
5
Single and Dual Pumping
The Ameda HygieniKit Milk Collection System can be used to single or dual pump.
To single pump:
Remove one tube and
close tubing adapter .
CONTROLS AND DISPLAYS
Using "Up/Down" Buttons
Before starting pump, please note how the controls
• Press and release controls to increase/decrease settings by increments of 1.
• Press and hold controls to increase/decrease settings by increments of 10.
speed suction
6 | ENGLISH
Adapter Cap
2
Silicone Diaphragm
1
Breast Flange
3 Valve
4
Milk Bottle
Tubing
Tubing Adapter
Operating the Pump
• When pump is plugged in, a light will appear next to the Power
• Press the Power
• Pump starts at lowest suction setting (1% or approximately 30mmHg / 4 .0kPa) and
maximum speed (80 cpm).
Ameda Platinum Breast Pump
To dual pump:
Both tubes should be
attached to tubing adapter.
work .
button. The displays light up. Pump is now ON.
• Place pump on a horizontal flat
surface before use .
• Attach Ameda supplied grounded
power cord to AC power inlet on
rear of pump .
• Connect grounded plug to wall
outlet .
• Ensure pump is positioned so that
the power cord from the rear is
accessible for removal.
• Insert tubing adapter into
tubing adapter port .
button.