Descargar Imprimir esta página

Joovy Twin Roo+ 9031 Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
FR ES
Please read these instructions carefully before use and keep them for future reference.
Your child's safety may be affected if you do not follow these instructions.
• For use ONLY on the Joovy TwinRoo+™ stroller.
• Always make sure the child is properly buckled into the infant car seat. Use of the stroller with two infants in their
infant car seats weighing more than 40 lbs. (18.14 kg) each or two infants totaling more than 80 lbs. (36.29 kg) will
cause excessive wear and stress on the stroller and may cause a hazardous unstable condition.
This stroller is compatible with specific infant car seat models. You can mix and match the car seats and the car seat can face the same
direction or opposite directions. For the most updated list of compatible infant car seats, please check our website at www.joovy.com.
Adapters for specific brands of infant car seats are sold separately.
Installing the Britax® B-Safe/BOB® B-Safe Car Seat Adapter for the TwinRoo+™
• To install the Britax® B-Safe/BOB® B-Safe car seat adapters make sure that the ends with the slot are facing down See Figure 1.1. and
that the sides with the release tabs are facing out. See Figure 1.2.
• Push the car seat adapters down into the brackets until they click into place. See Figure 1.3.
• Pull upward on each adapter to ensure it is secure.
• Lower the car seat onto the car seat adapters until it clicks into place. The car seat can face the left or right.
• Pull upward on the car seat to ensure it is secure.
• To remove the seat, pull up on the buttons found under both side of handle and lift the car seat up. See Figure 1.4.
Removing the Britax® B-Safe/BOB® B-Safe Car Seat Adapter
• Remove infant car seats from the stroller.
• Pull up on the release tabs found on the outside of the adapters and pull the adapters up. See Figure 2.1.
NOTE: You DO NOT need to remove infant car seat adapters to fold product
The infant car seat adapter is for use ONLY with specific infant car seat models
1.1
1.4
DO NOT install a product other than an infant car seat onto this unit.
1.2
2.1
WARNING
!
Britax®/BOB® B-Safe
Britax® B-Safe 35
Britax® B-Safe 35 Elite
1.3

Publicidad

loading