Hillsdale Furniture CAMERON ROUND DINING TABLE Manual De Instrucciones

Examine all packaging material for small parts that may have come loose during shipment. Periodic checks are recommended to insure that all
components are in proper position, tight and free from damage. Keep this assembly instruction for future reference. Adult assembly is required.
The product of Hillsdale Furniture, LLC is designed for residential use only. Customer Service Phone Number: 502-562-0000
HARDWARE LIST
A (4) 5/16" x 19mm Flat Washers
B (8) 5/16" Spring Washers
C (8) 5/16" x 2-3/4" Allen Bolts
D (1) 5mm Allen Wrench
E (8) 1/4" x 12mm Flat Washers
F (8) 1/4" Spring Washers
G (8) 1/4" x 1-1/4" Allen Bolts
H (1) 4mm Allen Wrench
I (4) 5/16" x 16mm Flat Washers
PARTS LIST
J (1) Table Top
K (1) Metal Ring
L (1) Leg Brace
M (4) Legs
FIGURE 1
I
B
C
G
F
E
M
M
K
M
L
FIGURE 2
CARE & MAINTENANCE: The touch of a soft cloth is all the maintenance the finish will ever need. Please do not use harsh or abrasive cleaners for polishing,
as they may cause damage to the finish. Periodic checks are recommended to make sure that all bolts, screws and nuts are securely tightened.
CAMERON ROUND DINING TABLE
Model #4671-814S / 837 Top and Wood Parts
Model #4671-815 / 838 Metal Ring
M
M
STEP 1
Begin assembly by attaching 3 of the Legs (M) to the Leg Brace (L) by
lining up the rods on the brace with the holes on the leg and secure
with 1 Allen Bolt (C), 1 Spring Washer (B) and 1 Flat Washer (I) for
each leg. See Figure 1.
M
STEP 2
L
Slide the Metal Ring (K) into place in between the three Legs (M) and
attach them to each other using 2 Allen Bolts (G), 2 Spring Washers
(F) and 2 Flat Washers (E). Then attach the remaining Leg (M) to the
Leg Brace (L) and the Metal Ring (K) in the same fashion as the
previous legs. See Figure 2. Tighten all bolts with the Allen Wrenches
(D & H) provided.
STEP 3
Turn the Table Top (J) upside down and lay it on
a clean smooth surface.
STEP 4
Finally attach the Leg Brace (L) assembly to the
Table Top (J) using 4 Allen Bolts (C), 4 Spring
Washers (B) and 4 Flat Washers (A). Tighten all
bolts. The assembly is now complete. See
M
Figure 3.
C
B
I
PART QTY HARDWARE
A 4
C 8
E 8
G 8
I 4
J
Date: 10-29-2014
Page 1 of 1
PART QTY HARDWARE
B 8
D 1
F 8
H 1
L
FIGURE 3
C
B
A