Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
Test Device Tronic for EnOcean Wireless, Item no. 480525
Intended use:
The test device (A) is used for the functional testing (see Block I)
of the MACO wireless sensors eTronic (EEP A5-14-01) and
mTronic (EEP A5-14-0A).
Together with the test transmitter (B), the test device can also be
used to test the ranges (see Block II) of the EnOcean signal in a
certain room / area.
Any other use is not planned for and also not permitted!
Scope of delivery
Test device (A)
Power supply
3x AA 1,5 V Mignon
(not included)
or
USB cable
Battery status is shown during the self-test when switched on.
Switch on
(short keystroke)
I) Check sensor signals (contact status)
Switch off the test transmitter, only one sensor may
be active!
Lock mode after alarm / sabotage must be reset on
the mTronic (see package leaflet)!
Alarm / Sabotage
Test transmitter (B)
Operate window /
door using handle
USB cable (C)
Change reception quality (to reduce the external influence of
sensors in the environment)
1x
1x
1x
1x
Additional information on the sensors:
- Wait for display of lock status sensor & battery status sensor, then
query additional handle position / sensor function.
- After a battery or mode change on the sensor, some complete
movements (Closed / Open / Tilted) must be carried out until the
test device displays the window status correctly again!
Operation and display
Self-test (diodes and battery status)
(~ 5 sec.)
1x
Self-test
finished
Standby mode
Test device display
1. Lock status sensor or
Alarm signal (mTronic only)
1x / 3 sec.
2. Battery Status /
Signal Quality
1x / 1 sec.
only signals with very good quality
only signals with good quality or better
only signals with medium quality or better
all signals are accepted
Manual power off or automatic shutdown
+
(long keystroke)
(4 red LEDs + acoustic signal)
II) Check signal range (with test transmitter)
1x / 2 sec
1. Switch on the test transmitter and
place it in the window rebate or in
the intended place of assembly.
+
2. Slowly back away from the test
transmitter with the test device
Signal strength is signalled via
LEDs and acoustic signal.
3. Turn off the test transmitter.
4. Exit test transmitter mode (short
button press on the test device).
Dispose of in accordance with local regulations
and laws!
www.maco.eu
Order No. 759384 / EN
Created: 05/2022 - changed: 04.07.2022
All rights and amendments reserved.
(~9 minutes of inactivity)
1x
1 sec
1 sec
3x
3x
+
1x
1x
Publicidad
