Mark DECO PAR 16 Manual De Uso

EN
DECO PAR 16
IMPORTANT SAFETY INSTRUCTIONS
1. Before you initially start-up, please make sure that there is no damage caused by transportation. Should there be any,
consult your dealer and do not use the device.
2. CAUTION! Be careful with your operations. With a dangerous voltage you can suffer a dangerous electric shock when
touching the wires! Keep away from heaters and other heating sources!
3. Do not mount the device on or near combustible sufaces.
4. Always hang the device with the color frame retaining clip in the locked position.
5. This device falls under protection-class I, therefore it is essential that the yellow/green conductor gets connected to
earth. The electric connection must be carried out by a qualified employee.
6. Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the power-cord
from time to time.
7. If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or
his service agent or a similar qualified person in order to avoid a hazard.
8. Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that
their effectiveness is impaired, for example by cracks or deep scratches.
9. Never let the power-cord come into contact with other cables! Handle the power-cord and all connections with the
mains with particular caution!
10. Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power-cord by
the plug. Never pull out the plug by tugging the power-cord.
11. During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily mean
that the device is defective.
12. DANGER OF BURNING! Never touch the device during the operation! The housing heats up to the housing
temperature T .
SURFACE
13. Don't switch the device on and off in short intervals as this would reduce the lamp's life.
14. HEALTH HAZARD! Never look directly into the light source, as sensitive persons may suffer an epileptic shock
(especially meant for epileptics)!
15. Keep away children and amateurs from the device!
16. There are no serviceable parts inside the device. Maintenance and service operations are only to be carried out by
authorized dealers.
Installing the Iamp
Always replace the lamp if it becomes damaged or deformed.
Caution! Operating lamps above their rated voltage reduces lamp life and can
cause premature lamp failure. For the installation, you need one PAR36 lamp
with up to max. 50W
1.Disconnect the unit from power before installing the lamp.
Let lamp cool before changing.
WARNING!
2.Remove the color frame from its holder .(Figure 1)
Note: To avoid premature lamp failure, do not touch the lamp glass with your
fingers. If you touch the lamp during installation, clean it carefully with
rubbing alcohol and a clean, lint-free cloth before operation.
3.Unscrew out the old lamp from the housing, and screw a new same model lamp into the socket.
4.Replace the color frame into the holder.
Rev. 130801
User Manual/Manual de Uso
Retaining clip
Colour frame
Colour frame holder
2
Figure 1
Yoke
Yoke locking knob
1 Push
Pag. 3