Descargar Imprimir esta página

FITRIDER Spinta SC3 Manual Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
Cleaning and Storage
Use a soft, wet cloth to wipe the mainframe clean. Hard to remove dirt can be scrubbed with a
toothbrush and toothpaste, then cleanedwith a soft, wet cloth. Scratches on plastic parts can be
polished with fine grit abrasive paper
NOTE
Do not wash your Escooter with alcohol, gasoline, acetone, or other corrosive/volatile solvents.
These substances may damage the appearance and internal structure of your Scooter. Do not
wash your Scooter with a power washer or hose.
WARNING
Make sure the Scooter is powered off, the charging cable is unplugged, and the rubber cap on
the charge port is tightly sealed before cleaning; otherwise you may damage the electronic com-
ponents.
Store your Scooter in a cool, dry place. Do not store it outdoors for extended periods of time. Ex-
posure to sunlight and temperature extremes(both hot and cold)will accelerate the aging process
of the plastic components and may reduce battery life.
Battery Pack Maintenance
Do not store or charge the battery at temperatures outside the stated limits(see Specifications).
Do not puncture the battery. Refer to your local laws and regulations regarding battery recycling
and/or disposal.
A well maintained battery can perform well even after many miles of riding. Charge the bat-
tery after each ride and avoid draining the battery completely. When used at room temperatu-
re(70°F[22℃])the battery range and performance is at its best;whereas using it at temperatures
below 32 F(0℃)can decrease range and performance.Typically, at-4°F(-20℃) range can be half
that of the same battery at 70°F(22℃).Battery range will recover when temperature rises.
16
www.spintabikes.com

Publicidad

loading