Publicidad
Idiomas disponibles
Idiomas disponibles
Press the headphones:
- Once: to play / pause or to answer / hang up a call.
- Twice: to reject a call or to increase or decrease the volume (left headphone to increase
the volume or right headphone to decrease the volume).
- Three times: to skip to the next song by pressing the right headphone, or to skip to the
previous song by pressing the left headphone.
- For 3 seconds: to activate Siri or the Google Assistant.
- For 5 seconds: to pair via Bluetooth.
- 5 times: in pairing mode to delete the paired device
BLUETOOTH PAIRING
Connecting a single (only) headset:
Press the button of one of the headphones to turn it on, after pressing this button for a
long time, you will notice that the LED light flashes red and blue, which means that the
Bluetooth of the headset is active and ready to connect to a device that has Bluetooth
(tablet, mobile phone, laptop, etc.).
To connect the headset to a player device, perform the following steps:
a. Turn on the Bluetooth of the source device.
b. Start the search for new Bluetooth devices.
c. Locate the name of the headphones (i12) and select them.
Once the pairing is successful, you can listen to music or make a call. The headphones will
turn off if they cannot be paired within 5 minutes.
To use the two headphones together, press the button on each of the headphones for a
few seconds at the same time until the LED light flashes (red and blue colours).
LISTEN TO MUSIC
Once your device is paired with the headphones, you can play music to the headphones
from it (using any radio, video or music application).
TO TURN OFF
Press the button on both headphones until the red light comes on and then stop press-
ing. If the source device is far away from the headphones, the playback is finished or it
is off, the headphones will turn off automatically after five minutes so that the battery
does not run out.
Publicidad
