The Homelite 12V replacement battery (p/n 207012001) is
compatible with Homelite tools that have a 12V internal bat-
tery. The tool shown is for illustration purposes. Replacement
battery installation instructions are the same for each tool.
TO REMOVE AND RECYCLE FACTORY
INSTALLED BATTERY PACK
See Figure 1.
Drain the battery by running the tool until it shuts off.
If applicable, make sure the switch trigger is in the off
position.
Look for the Phillips head screws near the charging port
to locate the battery compartment door.
Unscrew the screws and set aside.
Remove the battery compartment door.
Pull the battery out of the tool and separate it from the
two wire connectors.
NOTE: Take note of wire locations when removing the
battery.
Apply tape over the ends of the wire connectors for
battery disposal.
To preserve natural resources, please recycle or dispose
of batteries properly.
This product contains lithium-ion batteries.
Local, state or federal laws may prohibit dis-
posal of batteries in ordinary trash.
Consult your local waste authority for infor-
mation regarding available recycling and/or
disposal options.
WARNING:
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy
or disassemble battery pack or remove any of its com-
ponents. Lithium-ion batteries must be recycled or dis-
posed of properly. Also, never touch both terminals with
metal objects and/or body parts as short circuit may
result. Keep away from children. Failure to comply with
these warnings could result in fire and/or serious injury.
TTI OUTDOOR POWER EQUIPMENT, INC.
P.O. Box 1288, Anderson, SC 29622
1-800-242-4672 • www.homelite.com
12V BATTERY
207012001
TO INSTALL REPLACEMENT BATTERY
PACK
See Figure 1.
If applicable, make sure the switch trigger is in the off
position.
Locate the two wire connectors in the tool battery
compartment.
Connect battery wire connectors to the tool wire con-
nectors as shown.
Insert connected battery into battery compartment.
Tuck wires around battery so that they fit completely
inside the compartment.
Replace battery compartment door making sure that
the battery and wires are completely inserted inside the
compartment.
Secure battery compartment door with Phillips head
screws.
Fig. 1
D
C
A - Phillips head screws (vis à tête Phillips, tornillo de cabeza Phillips)
B - Battery compartment door (couvercle du compartiment des piles, puerta
del compartimiento de la batería)
C - Battery (pile, batería)
D - Wire connector (connecteur de fil, conector de cable)
D
B
A
999000181
1-13-23 (REV:01)