ledscom LC-EL-095-WW Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2a. Mounting with clamping spring (Figure
1):
1. Slide the two clamping springs (2) into
the holders (3) provided for this purpose on
the side of the light.
2. Prepare the installation opening. In
order for the springs to hold the light, the
width of the opening should be between
65mm - 70mm and the height should be
60mm.
3. Connect the wires of the light according
to "Figure 1".
4. Place the light in the opening.
2b. Mounting in a flush-mounted box
(Figure 2):
1. Connect the wires of the light according
to "Figure 3".
2. Place the luminaire (4) in the flush-
mounted box and fix it in place with the aid
of the two screws (5).
3. Press the metal cover (1) back onto the
light (4). Pay attention to the correct
position of the notches on the top and
bottom.
4. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Staircase light (LC-EL-095-WW) - Assembly instructions
Figure 1
Figure 2
1: Metal screen
2: Clamp springs
3: Clamp spring holder
Figure 3
4: Luminaire
5: Screws
11/2022