Mark SUPERBAT LED WI 712 Manual De Uso página 13

6.12 AUTO RUN, SELF-PROGRAM RUN
1)Press the 【ENTER】button in 【AUTO】menu, then enter to the auto run,self-program run.
2)Press the 【UP/DOWN】button to select 【AT01】...【AT05】，【SPEED 】，【CHASE01 】...【CHASE03
】
3)Press the 【ENTER】button to start running.
6.13 EDIT SELF-PROGRAM
1) Press the【ENTER】button in 【PROG 】menu, then enter to the edit self -program.
2) Press the【UP/DOWN】button to select 【CHASE01 】...【CHASE03 】
3) Press the【ENTER】button for confirmation and enter to the next menu.
4) Press the【UP/DOWN】button to select 【SCENE01 】 ...【SCENE20 】
5) Press the【ENTER】button for confirmation and enter to the next menu.
6) Then press the【UP/DOWN】button to select 【RED】...【SHUT】，【TIME】，【WAIT 】，【USE】
7) Press the【UP/DOWN】button to set up the parameter which are needed.
8) Press the【ENTER】button t o escape and save.
Illustrations ：When 【 USE】 is set to be 【NO】 ，or the parameter of 【 TIME】 is 0, it will not run this scene.When
【WAIT 】is set to be FADE time, the running process isas the following chart showing.
6.14 CHECK THE LIGHTING INFOR MATION
1) Press the【ENTER】button in 【INFO】menu, then enter to the checking the lighting information.
【 】
2) SOFT button is for software version information.
3) 【POW】button is for the current information of power reduction. It is 100% output in normal conditions, but
80% or 50% output in over temperature protection situation.
【 】
4) BAT Remaining battery power, from 0-10
SUPERBAT LED WI 712 - 12 -
User Manual/Manual de Uso
EN