Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for illuminate any areas
requiring additional light.
Before putting into operation
1. RECHARGING BATTERIES
a) CHARGING THE BATTERY
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot. Allow time for
the battery to cool down before recharging.
WARNING! Do not continue to press the
On/Off switch after the tool has been
automatically switched off. The battery can be
damaged.
b) IMPORTANT NOTES FOR
CHARGING THE BATTERY
The battery in your new tool is not charged when
it leaves the plant. Therefore it must be full
charged before using the first time
NOTE: If the battery pack is very hot you must
remove your battery pack from the charger and
allow your battery pack to cool first to ambient
temperature and then recharging can be started.
To prevent damage to the Battery Pack, when
charge runs out, please charge the battery to
reach full or no less than half charge before
storage.
If the tool will not be used for long
periods of time, charge the battery
every 3-6 months
c) CHARGING (SEE FIG. A)
Plug the charger into an appropriate outlet. The
light (a) will be green.
14
Insert the Battery Pack (4) into the charger,
the light (b) will be red to indicate the charging
process has started.
1) On completion of charge, the light (a) is green,
and light (b) will be off. The pack is now fully
charged, unplug the charger and remove the
battery pack.
WARNING: When battery charge runs
out after continuously use or exposure to
direct sunlight or heat, allow time for the tool to
cool down before re-charging to achieve the full
charge.
2. REMOVE OR INSERT BATTERY
PACK (SEE FIG. B)
Press the battery pack release button and remove
the battery pack from the tool. After recharge
slide the battery pack into tool's battery port. A
simple push and slight pressure will be sufficient.
OPERATION
1. ON/OFF SWITCH
The torch produces a light beam that emerges
from the lamp head (1).
To start the torch, depress forward the ON/OFF
switch (2).
To turn off, depress backwards the ON/OFF
switch again.
2. TEMPERATURE DEPENDENT
OVERLOAD PROTECTION
When using as intended for, the power tool
cannot be subject to overload. When the load is
too high or the allowable battery temperature
of 75 °C is exceeded, the electronic control
switches off the power tool until the temperature
is in the optimum temperature range again.
3. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep
discharging by the "Discharging Protection
System". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
EN
Publicidad
