EN Operating instructions
10
3 Laser receiver
3.1 Display and operating elements of the laser receiver
Display lights up: limited remaining life
1
(battery approx. 5h / rechargeable battery approx.
1h). Display flashes: Switching off imminent, replace
rechargeable batteries/batteries!
Lights up if the laser line is within the sensor window
2
but below the zero line. In addition, the red LED next
to the reception field lights up and a slow intermittent
LCD display DETECTOR FIELD RESOLUTION
3
Displays the currently set resolution:
Lights up if the laser line is located at the level of
4
the zero line. In addition, the green LED next to the
reception field lights up and a continuous tone is also
Lights up if the laser line is within the sensor window
5
but above the zero line. In addition, the yellow LED
next to the reception field lights up and a fast intermit-
6
7
Shows the distance to the reference / zero marking
LCD display ACOUSTIC SIGNAL
8
Display = acoustic signal quiet/
No Display = acoustic signal off
Button ACOUSTIC SIGNAL
9
Switches the acoustic signal between
10
Switches the receiver on and off.
Button DETECTOR FIELD RESOLUTION
Short press: Switches the resolution between fine =
11
Long press (> 3 sec.): Switches over the measuring
LCD display BATTERY
LCD display LOWER
tone is also emitted.
fine = ±1 / rough = ±4 mm
LCD display TARGET
emitted.
LCD Display HIGHER
tent tone is also emitted.
LCD display „mm"
Shows the unit.
LCD display "height"
Display = acoustic signal loud/
loud/quiet/off.
Button ON/OFF
±1mm / coarse = ±4mm.
range (near/far) (see 3.2).
1
8
7
11
10
2
3
4
(3)
5
6
(2)
(4)
(5)
9