Rear Panel; Side Panel - Work Pro W MMX 62 Manual De Uso

REAR PANEL

9 8
DC 24V DC 24V 0.5A
Use only with a 250V fuse Use only with a 250V fuse Use only with a 250V fuse
1. MIC 1 TALKOVER - This trimmer adjusts the threshold TALKOVER of MIC 1 for priority purpose.
2. MONO INPUT SOURCE - It allows to select the source type on each mono input channel (MIC, LINE
or PH). In this last position, the device provides phantom power to supply a condenser microphone
( +18V - 20V DC).
3. MONO INPUT CONNECTOR - This combi connector (XLR 3 pin /Jack 1/4" allows to connect a LINE
or MIC device (selecting the correct source with switch (2)).
4. STEREO INPUT CONNECTORS - It is possible to connect stereo input signal through these unbalanced
RCA connectors.
5. REC OUTPUT - It is possible to send the complete mising information to an external recording device
through these unbalanced RCA connectors.
6. MONO OUTPUT - This balanced mono output through XLR 3 pin connector allows to send signal to
p.e. a subwoofer system.
7. L & R MASTER OUTPUT - These balanced LEFT & RIGHT outputs through XLR 3 pin connectors
allows to send the final mix to and external amplifier system.
8. 24 V DC - For emergency purpose, it is possible to supply the device through these 24 V DC terminal
with an external DC power supply.
9. AC INPUT CONNECTOR - Connect the included IEC cable in order to supply the device.

SIDE PANEL

1
1. AC SELECTOR - Use this selector switch to choose the correct AC voltage value. Please confirm
the correct value before to connect the device.
7 6 5
3
4
User Manual/Manual de Uso
EN EN
3 2
1
MMX 62