Publicidad
Idiomas disponibles
Idiomas disponibles
FRONT PANEL:
1: Main switch
Used to turn on and off the amplifier. A few seconds after switching on the amplifier it is ready for operation.
2: CH1/CH2 Gain controls
These potentiometers are used to control the input sensitivity of the amplifier for the satellites. Each channel has its
own control.
You can use these controls to set the maximum sound level of your setup:
• Turn both controls on the amplifier (1) to the left.
• Put on some music on and make sure the VU meters on your mixer are at 0dB. (from time to time the red zone is
lit)
• Set the Master output from your mixer to maximum.
• Open the Gain controls from the amplifier (1) until the ma$imum desired sound level is reached.
• Make sure nobody can reach the Gain controls of the amplifier. You have just set the ma$imum level the DJ is able
to produce. Your neighbors will be glad.....
3. SUB bass gain control: This potentiometer is used to control the sensitivity of the sub bass amplifier. Put on some
music and turn this control slowly up until there?s a nice balance between the high/mid satellite speakers and the
subwoofer.
4: Protect LED:
The protection LED is on when the speakers are disconnected from the amplifier. This occurs in the following
situations:
5: Clip LED
Turns on just before the maximum, distortion free, output level of the amplifier. The clip leds may turn on shortly
from time to time but they may certainly not turn on for longer periods. In this case you have to turn the output level
down!
6: SUB phase invert indication LED
Truns on when the phase invert switch( rear panel) was pressed, indicate current SUB output phase was
180°inverted.
4
(in some cases the DJ is not
)
Publicidad
