Publicidad
Idiomas disponibles
Idiomas disponibles
1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Prepare the substrate for installation:
For stone floors, drill two holes (3), each 6
mm Ø, in the floor and insert the supplied
dowels (2) there. The dowels (2) must be
flush with the floor. For the connection
cable (4), an approx. 25 mm Ø large hole
(5) must be drilled.
When installing in wood, you only need to
drill the hole for the connection cable (4).
The dowels are not needed here. The
screw holes (3) should not be larger than
1mm Ø.
3. Guide the connection cable (4) through
the connection opening (5) and fix the light
to the base using the screws (1) supplied.
4. Connect the connection cable if
necessary. with an extension cable or
directly with a transformer that has the
appropriate plug-in system (Figure 2).
Screw the cap tightly to protect the
connection from water. Make sure that the
screw cap is not in the water.
5. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Screws
2: Dowel
3: Screw holes
Figure 2
Floor lamp (LC-EL-088-WW) - Assembly instructions
4: Connection line
5: Connection opening
11/2022
Publicidad
