dibea UV-10 Manual De Instrucciones página 5

Operation
Power switch
Connect the supply cord to the sockect, press
the power switch, the vacuum cleaner motor
and the roller brush will start to work. Press the
switch again to stop the machine. Both the roller
brush and the UV light have the safety protec-
tion sensors. They will stop working once the
vacuum cleaner is lift up over 5cm from the
surface.
Note: The UV light will automatically work,
doesn't need any manual operation
Note: When the UV indicator lights turn on, it means the UV light is working
Installing of Main Body and Dustbin Installing of Main Body and Dustbin Installing of Main Body and Dustbin Installing of Main Body and Dustbin
Make sure cut off the power before assembly
or disassembly
Installing: Press the dustbin lock button and
pick up the dustbin.
Uninstalling: The bottom hooks of dustbin plug
into the main body and push in
Installing of Dustbin and Filter Installing of Dustbin and Filter Installing of Dustbin and Filter
Turn left the dust cup and it separates from the cover
Turn right the dust cup and connect with the cover.
Note: the air inlet should be downwards. Note: the air inlet should be downwards. Note: the air inlet should be downwards
when install dust bin. when install dust bin. when install dust bin.
On/Off
dustbin Hook
main body groove
dustbin
lock button
left
right
Air inlet
transparent dust cup
Take out the filters: Move along the vertical direction of the dust cup.
Note: Put in the cyclonic filter before hepa filter when installing.
Installing of Rotating brush and Rotating Brush Holder
Installing of Rotating brush and Rotating Brush Holder Installing of Rotating brush and Rotating Brush Holder
Rotating brush and rotating brush holder is
assembled together at the factory.
Use a coin rotate 90 degrees along the mark
and take out the holder.
Operation
button
hepa filter
cyclonic filter
Rotating Brush Holder
Rotating Brush