Publicidad
Idiomas disponibles
Idiomas disponibles
Refrigerator compartments are too warm
• The door is opened frequently.
• A large amount of warm or hot food was stored recently.
• The refrigerator has been disconnected for a long time.
Food is frozen
• The temperature was set too low.
There is "water flow" noise from inside the refrigerator
• It's a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops around the refrigerator casing or door gap
• It's a normal phenomenon, the moisture will condense to water when it touches a cold
surface of the refrigerator.
The compressor is slightly noisy when starting
• It's a normal phenomenon, the noise will be reduced after the compressor works stably.
Code F1 displayed
• Possible cause: low voltage to fridge. Adjust the battery protection from High to Medium or
from Medium to Low.
Code F2 displayed
• Possible cause: condenser fan is overloaded. Disconnect power to fridge for 5 minutes & re-
start. If the code shows again, contact manufacturer for service.
Code F3 displayed
• Possible cause: the compressor starts too frequently. Disconnect power to fridge for 5
minutes & re-start. If the code shows again, contact manufacturer for service.
Code F4 displayed
• Possible cause: compressor not kicking in. Disconnect power to fridge for 5 minutes & re-
start. If the code shows again, contact manufacturer for service.
Code F5 displayed
• Possible cause: overheating of the compressor & electronics. Disconnect power to fridge for
5 minutes & re-start. If the code shows again, contact manufacturer for service.
Code F6 displayed
• Possible cause: no parameter can be detected by the controller. Disconnect power to fridge
for 5 minutes & re-start. If the code shows again, contact manufacturer for service.
Publicidad
