Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself
with its remote control. The following is a brief introduction to the remote control
itself. For instructions on how to operate your air conditioner, refer to the How to
Use Basic Functions
ON/OFF
Turns the unit on or off.
TEMP
Increases temperature in 1°
C (1°F) increments. Max.
temperature is 30°C (86°F).
NOTE: Press together
buttons at the same
time for 3 seconds will
alternate the temperature
display between the °C & °F.
SET
Scrolls through operation
functions as follows: Fresh
( ) > Sleep ( ) > Follow
Me( ) > AP mode (
Fresh...
The selected symbol will
flash on the display area,
press the OK button to
confirm.
TEMP
Decreases temperature
in 1ºC (1ºF) increments. Min.
temperature is 16ºC (60ºF)
FAN SPEED
Selects fan speeds in the
following order: AU > 20% >
40% > 60% > 80% > 100%
Press the TEMP or button to
increase/decrease the fan
speed in 1% increments.
Starts and stops the
horizontal louver move-
ment. Hold down for 2
seconds to initiate vertical
louver auto swing feature.
section of this manual.
&
) >
SWING
Model:
ECRL10A2
5
MODE
Scrolls through operation
modes as follows: AUTO >
COOL > DRY > HEAT > FAN
NOTE: HEAT mode is not
supported by the cooling
only appliance.
ECO/GEAR
Press this button to enter the
energy efficient mode in the
following sequence:
ECO > GEAR 75% > GEAR 50%
> Previous setting mode >
ECO...
OK
Used to confirm the selected
functions
TIMER
Set timer to turn unit on or off
BREEZE AWAY
This feature avoids direct air
flow blowing on the body.
Note: This feature is available
under COOL, Fan and Dry
mode only
CLEAN
Used to start/stop the Self Clean
or Active Clean function.
(Model dependent, please refer to
the USER'S OPERATION &
INSTALLATION MANUAL).
LED
Turns indoor unit's LED display
and air conditioner buzzer on and
off (model dependent), which
create a comfortable and quiet
environment.
Turbo
Enables unit to reach preset
temperature in shortest
possible time
V.1