Descargar Imprimir esta página

EAS ELECTRIC ECRL10A2 Manual De Instrucciones página 17

Ocultar thumbs Ver también para ECRL10A2:

Publicidad

Idiomas disponibles

Idiomas disponibles

Handling the Remote Controller
Inserting and Replacing Batteries
Your air conditioning unit may come with
two batteries (some units). Put the batteries
in the remote control before use.
1. Slide the back cover from the remote
control downward, exposing the batte-
ry compartment.
2. Insert the batteries, paying attention
to match up the (+) and (-) ends of the
batteries with the symbols inside the
battery compartment.
3. Slide the battery cover back into place.
BATTERY NOTES
For optimum product performance:
• Do not mix old and new batteries, or
batteries of different types.
• Do not leave batteries in the remote
control if you don't plan on using the
device for more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for
proper disposal of batteries.
TIPS FOR USING REMOTE CONTROL
The remote control must be used
within 8 meters of the unit.
The unit will beep when remote signal
is received.
Curtains, other materials and direct
sunlight can interfere with the infrared
signal receiver.
Remove batteries if the remote will not
be used more than 2 months.
NOTES FOR USING REMOTE CONTROL
The device could comply with the local na-
tional regulations.
 In Canada, it should comply with CAN
ICES-3(B)/NMB-3(B).
 In USA, this device complies with part 15
of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide rea-
sonable protection against harmful interfe-
rence in a residential installation. This equip-
ment generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no gua-
rantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television
reception,
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
Reorient or relocate the receiving ant-
enna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications not
approved by the party responsible for
compliance could void user's authority
to operate the equipment.
4
which
can
be
V.1

Publicidad

loading