HC Cargo 161128 Manual De Instrucciones página 2

Installation/Wiring:
OUTPUT
BATTERY 1
VEHICLE
To vehical ignition system
headlights, horn etc.
Programming Function:
First, connect all the wires as the wiring diagram as above.
Enter programming mode: Press and hold the button for more than 3 seconds to enter
the programming function. The LED on the top of the unit will flash a number of times
indicating the current programme number (one for P1, twice for P2, etc.) .
Setting and replace: within 60 seconds,
through the programme number(once for P1, pause 2 sec, twice for P2, pause 2 sec,
etc.). When the number of the required programme is reached press the button once.
The LED will flash the number of times three times to confirm the programme number
selected and then save the programme and quit automatically.
Programmes specifications:
Programme
P1
P2
P3
P4
P5
P6 (Default)
P7
P8
P9
ALTERNATOR
Ground
Positive Sense Batt.
Positive Aux. Batt.
Override: to 12V+ power via
12V Momentary switch
press button once,
Cut-off
Voltage delay
10V 5 sec
11.7V 5 sec
10.5V 5 sec
10.5V 5 sec
11.25V 5 min
11.5V 5 min
11.5V 5 min
11.8V 5 min
12.8V 5 min
FUSE (150A)
BATTERY 2
AUXILIARY
To auxiliary equipment
stereo, lights, winch, etc.
the LED will start to sequence
Voltage
11.5V
13.2V
12V
12.8V
13.25V
12.8V
13.8V
12.8V
13.2V
2
161128
Cut-in
delay
5 sec
5 sec
5 sec
5 sec
5 sec
5 sec
5 sec
5 sec
5 sec
Vedpak 230_Version 1_05.2020