Publicidad
Idiomas disponibles
Idiomas disponibles
EN
12. GENERATOR ASSEMBLY AND MOUNTING
If your generator is supplied with a wheel kit. please follow the instructions below
1. Place the bottom of the generator cradle on a flat, even surface. Temporarily place unit on blocks
to ease assembly.
2. Slide axle through both mounting braces on the cradle frame as shown(Fig 1)
3. Slide a wheel (with the inflation valve facing out)and a flat washer over the axle, then secure the
wheel with a retaining pin(Fig 2.Fig 3.Fig 4)
4. Install the other wheel in the same manner
5. Secure each vibration mount to the support leg with a lock nut, and a cap screw (Fig 5):
6. Secure the support leg to the cradle cap screws and lock nuts (Fig 6):
7. Position the handles on the cradle, cap screws and lock nuts (Fig 7.Fig 8.Fig 9)
8. Check that all fasteners are tight and tires are inflated between 15-40 PSI
28
Publicidad
