SOLAC JP5921 Instrucciones De Uso página 9

Jarras JP_5921.book Page 9 Tuesday, December 11, 2007 5:35 PM
unevenly or stop flowing, this means that the filter still contains air
bubbles. Repeat the steps given in paragraph 2. (Fig. 4).
5 After changing or replacing the filter, the first two filling operations are
intended to clean and activate the granulate. For this reason, the water
will come out slightly darker in colour. Use the first two filling operations
to water your plants or just throw away the water. The jug of filtered water
is now ready for use. (Fig. 5).
4 INSTRUCTIONS FOR REPLACING THE SOLAC
PURIFYING FILTER

The ecological system used to replace the filters enables you to use
them several times and replace them with Solac purifying sachets. The
rechargeable filter is also universal and compatible with other jugs.
1 Turn the lid to open the filter. (Fig. 7).
2 Empty out the contents. The granulate can be disposed of together with
household waste or used as a fertiliser for plants.
3 Fill the filter with the new granulate. Close the filter again. Follow the
instruction of paragraph 2 in the section entitled "Instructions for the first
use". (Fig. 8).
5 INSTRUCTIONS FOR THE SOLAC "INTELLIGENT"
ELECTRONIC INDICATOR

The new SOLAC electronic indicator gives precise information to remind
you when to refill the filter. It is so precise that it enables you to stop
calculating the life of the filter during periods when the jug is not in use.
This way, we can get maximum use from the refill.
1 If you are not going to use the jug for some time, stop the counter so as
to avoid including this time in the life of the filter. To stop the counter just
release the tab for 5 minutes.
2 To start the counter again, just reset it. To reset the indicator, remove
and press the tab 5 times in a row.
3 Indicates the need to change the filter after 6 weeks or *100/150 fillings.
*100 fillings for the pitcher of 3.3 L and 150 fillings for the pitcher of 2.4L.
INSTRUCTIONS FOR REPLACING THE SOLAC PURIFYING
en
9