Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly (continued)
9
Mantel Top installation
Locate Mantel/Top (G) and lay finished side up on top of
completed assembly.
From the inside, attach the Mantel/Top (G) using
Bolt (AA) through the pre-drilled holes in the Plastic
Connector. Hand Tighten Only.
Use a Phillips head screwdriver, tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
Part
Description
AA
Bolt
AA
G
11
Door installation
Locate Right Front Door (M) and Left Front Door (L)
and slide door hinge keyhole into panel hinge bracket.
(Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES:
To adjust door forward or backward change
keyhole slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten
screw. (As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (FF) to the Left Front Door (L) and
Right Front Door (M), using the bolts attached through
the pre-drilled holes in the doors.
Use a Phillips Head Screwdriver to tighten the bolts.
10
Back Panel installation
Attach the Side Back Panel (K) and the Center Back
Panel (Q) to the back of the completed assembly from
step 9.
Using a Phillips Head screwdriver, tighten screws (EE)
through the pre-drilled holes in the Back Panels to the
completed assembly.
Use a Phillips Head Screwdriver to tighten the bolts that
were left hand tightened.
Hardware Used
Qty
Part
5
EE
K
Hardware Used
Part
FF
10
Description
Screw
EE
Description
Knob
M
L
Qty
24
Q
K
Qty
2
FF
Publicidad
