Napier Sportz 57 Serie Instrucciones página 3

Assemble the tent poles by
4
unfolding each section.
POLE LOCATION
Blue Poles Corner-to-Corner
Green Pole Side-to-Side
Grey Short Pole Rear Cab
Grey Long Pole Vestibule/Tailgate
Black Pole Front-to-Back (inside)
Insert each pole into the corresponding colored pocket in the following order:
6
GREEN (side-to-side) pole into webbing pocket above the windows
•
BLUE (corner-to-corner) pole into the pocket near the truck cab. Insert the other end
•
into the pocket by the tailgate. Repeat with the other blue pole
SHORT GREY (rear cab) pole into the grommet holes
•
LONG GREY (tailgate) pole
•
BLACK (inside front-to-back) pole. Secure
•
the pole to the tent using the Velcro tabs
NOTE: Ensure tailgate pole is set-up
on the outside of the tailgate wires.
(If pole is set up inside the tailgate
wires it will create too much
tension and may cause pole to break).
Insert the poles into the corresponding color sleeve in the following order (do not place the poles in the corner pockets at this time):
5
BLUE pole diagonally, corner-to-corner on the roof of the tent. Repeat with the other blue pole
•
GREEN pole side-to-side on the roof of the tent. The green pole should be on top of the blue poles
•
SHORT GREY pole side-to-side at the back of the tent, near the truck cab
•
LONG GREY pole side-to-side at the front (tailgate) of the tent.
•
Ensure the tailgate pole is even on both sides.
NOTE: The poles may
get stuck in the
sleeve. Do not force
them – gently guide
the pole through
the fabric sleeve.
Once the tent is fully raised, attach
7
the pole clips to the poles.
BLUE
SHORT
GREY
GREEN
LONG
GREY
BLUE
If the tent straps on the side of the
8
truck are too loose, pull to tighten.
Ensuring not to make them too tight.
To install the gear loft, place each
9
corner hook of the gear loft into the
loop located on the ceiling of the tent.