Sulion YUKA Manual página 3

EN
Caution
Follow these instructions carefully,especially when fixing to the cei-
ling (if not assembled properly it can be dangerous)*, to enjoy maxi-
mum safety in the installation and performance of this equipment.
Do not throw away electrical products together along with house-
hold waste. Please recycle the packaging at the collection points
provided for this purpose. Contact local authorities or your provider
for recycling advice. Thank you for recycling them at the collection
points provided for this purpose.
The installation must be carried out by qualified personnel to per-
form electrical installations in accordance with the regulations in
force in the country of installation.
The light source of this luminaire is replaceable.
Note: Important warnings and instructions in this manual do not guarantee
covering all possible conditions and situations that may occur. It should be
understood that common sense, caution and care are factors that cannot be
included in all products. These factors can only and should be provided by
the user who takes care of and enjoys this product.
Installing the product
See installation steps at the end of this manual
Network conection
1.- Screw type terminal
2.- Class II: 2 Poles (L + N) / Class I: 3 Poles (L + N + TT)
3.- Assigned Voltage 250V and Current 10A.
4.- The terminals must have a minimum capacity of 1.5mm ² for indoor lighting and 2.5mm ² for outdoor
lighting.
5.- Verify that the connection block is suitable for the output cable, either a unipolar cable or a bipolar / tripolar
cable.
6.- Check if the connection block to be included must be fixed on the luminaire. It must always be kept away
from heat sources.
7.- IP grade. It must be according to the IP grade marked on the luminaire
8.- In accordance with the EN 60998-2-1 or EN 909998-2-2 standards.
* Respect the color code according to the terminal (L = Brown, black or gray. N = Blue, Ground = Green and yellow)
* Minimum values. In cases of powers higher than 2500W, check the current to know the characteristics of the
connection lock.
* Check if the connection block requires ferrules or special preparation for a correct connection.
- The data shown in this table are merely informative and do not constitute, in any case, unique conditions of
connection to ref by the user or installer. In case of opting for another connection block, the conditions of use
that the EN 60598-1 standard establishes must be respected, highlighting the requirements of creepage distan-
ces and distances in the air for grid connection blocks.
Type A: For making connections inside Class I luminaires. The class II version is similar, but with two poles.
Type B: To make connections to the exterior of Class I luminaires. The Class II version is similar, but with two poles.
Type C: To make connections outside luminaires with class I disconnection. The class II version is similar, but with
two poles. Check that the cable diameter is suitable for the type of connection block.
Type D: To make connections outside luminaires with Grade> IP20. Check that the cable diameter is suitable for
the type of connection block.
www.sulion.es
CIF A28763647 +34 916774540
Warranty
The Manufacturer guarantees the correct functioning of the equipment
and possible free repairs or supply of free spare parts of the model due to
manufacturing defects for 3 years from the date of delivery and 5 years
exclusively in the case of the components corresponding to the LED, but
cannot be held responsible for damages and/or losses caused by misuse
of the LED.
For any claim, the purchase receipt must be attached to this warranty.
If the Manufacturer chooses to repair the product and it is not satisfac-
tory or chooses to replace a defective product or send a spare part, but
cannot do so because it is no longer manufactured or is not available,
the Manufacturer may return to the buyer the amount paid or replace the
product with another comparable product (whose design or specifica-
tions may vary slightly).
On the other hand, if the Manufacturer, within the 10-year repair parts
maintenance period, is out of stock or no longer manufactured, the Ma-
nufacturer agrees to repair the product or give the customer a discount
on a new or reconditioned product with the same or equivalent charac-
teristics.
Terms and conditions of guarantee in https://sulion.es/es/conten-
t/12-terminos-y-garantia
EC Declaration
SULION hereby declares that the type of luminary YUKA (Ref: 112308)
is in accordance with Directive 2014/53/EU y RoHS 2011/65/UE)
The full text of the EU declaration of conformity is available on the fo-
llowing internet address: www.sulion.es/en
ATC: 916749481 - info@sulion.es / SAT : 916749483 - sat@sulion.es
Calle Verano, 51 - 28850 Torrejón de Ardoz - Madrid (España)