Publicidad
Idiomas disponibles
Idiomas disponibles
B
02
Installing Latch Assembly
A
Step 1: Using a pencil, mark the two holes on the inside edge of the fence post for the mounting plate.
Step 2: Drill 2 pilot holes using a power drill and a 1/8" (3mm) drill bit.
Step 3: To install the latch assembly, tighten the 2 lag bolts "clockwise" using a 17/32" (13mm) wrench.
You may also use a 17/32" (13mm) socket on your power drill. Do not over-tighten.
Installing Keeper bar
Step 1: With gate closed, inset the keeper bar (B) into the latch assembly.
Mark the two holes with a pencil.
Step 2: Drill 2 pilot holes using a power drill and a 1/8" (3mm) drill bit.
Step 3: To install the keeper bar, tighten the 2 lag bolts "clockwise" using a 17/32" (13mm) wrench.
You may also use a 17/32" (13mm) socket on your power drill. Do not over-tighten.
Publicidad
