Publicidad
Enlaces rápidos
3717348COM
TV Stand
Date of Purchase ___ / ___ / ___
Lot Number:
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Do Not Return This Product!
Contact our customer service team for help first.
Call: 1-800-489-3351 (toll free)
Monday-Friday 9am - 5pm CST
Visit: www.ameriwoodhome.com
WARNING
- Unit can tip over causing severe injury or death.
- Anchor unit to stud in wall (if instructed to).
- Do Not allow children to climb on unit.
- Put heavy items on lower shelves or drawers.
Easy
Assembly Difficulty Meter
B343717348COM0
Tough
Publicidad
Manuales relacionados para Dorel Home Products 3717348COM
Resumen de contenidos para Dorel Home Products 3717348COM
- Página 1 3717348COM TV Stand B343717348COM0 Date of Purchase ___ / ___ / ___ Lot Number: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. Do Not Return This Product! Contact our customer service team for help first.
- Página 2 Contact Us! Do NOT return this product! Contact our friendly customer service team first for help. Assembly Tips Call us! 1-800-489-3351 Monday-Friday 9am - 5pm CST Tube Visit ameriwoodhome.com to view the limited warranty valid in the U.S. and Canada. Helpful Hints PEOPLE NEEDED FOR ASSEMBLY: 2 - Open your item in the area you plan to keep it to avoid excessive heavy lifting.
- Página 3 Before You Start Read through each step carefully and follow the proper order Separate and count all your parts and hardware Parts are labeled on the surface or edge of the part Give yourself enough room for the assembly process Have the following tools: Flat Head Screwdriver, #2 Phillips Head Screwdriver and Hammer Caution: If using a power drill or power screwdriver for screwing,...
- Página 4 Please Note: You may need to lightly tap the wood dowels into the holes during your assembly process.
- Página 5 Board Identification Not actual size Left Panel Right Panel Upper Partition Lower Partition 33717348010 33717348020 33717348030 33717348040 Shelf Bottom 33717348050 33717348070 33717348060 Left Rail Front Rail Rear Rail Top Rail 33717348110 33717348090 33717000100 33717348080...
- Página 6 Board Identification Not actual size Right Outer Door Left Inner Door Right Rail Left Outer Door 33717355150 33717348120 33717355130 33717355140 Back Panel K371734800 This part is paperboard construction. Right Inner Door It is not made from wood, but is 33717355160 required for the assembly of your unit.
- Página 7 Part List Note: Your model may have Actual Size extra hardware included. (x16) (x8) (x16) (x4) (x9) #A21670 #A23030 #A22760 #A89370 #A12120 wood dowel confirmat screw quickloc door bumper #8 x 7/16" panhead screw (x17) (x18) (x18) #A21110 #A22700 #A22710 nail cam lock cam bolt...
- Página 8 STEP 1 (x8)
- Página 9 STEP 2 Quick Assembly Proper orientation of CAM LOCK (x4) (x2)
- Página 10 STEP 3 Quick Assembly Proper orientation of CAM LOCK (x4) (x4) (x2)
- Página 11 STEP 4 Quick Assembly Proper orientation of CAM LOCK (x4) (x4) (x2)
- Página 12 STEP 5 (x4) unfinished edge Turn clockwise to lock in place. Press four quickloc fasteners (3) into holes in top (E). With top rail (H) laying flat with larger holes (4 holes) facing up, press top (E) onto top rail (H) so quickloc fasteners (3) engage into holes.
- Página 13 STEP 6 finished edge s face up...
- Página 14 STEP 7 (x2) finished edge s face up...
- Página 15 STEP 8 finished edge s face up...
- Página 16 STEP 9 finished edge s face up...
- Página 17 STEP 10 (x6) finished edge s face up...
- Página 18 STEP 11 (x9) (x17) IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS UNIT AND MUST BE INSTALLED PROPERLY. With the help of another person, carefully turn your unit onto its front. Position back panel as shown. Align squarely with edges of bottom, left panel and right panel.
- Página 19 STEP 12 (x2) (x4) Note: Be sure to use the holes shown for the cam bolt (8).
- Página 20 STEP 13 Quick Assembly Proper orientation of CAM LOCK (x4) (x8) (x4)
- Página 21 STEP 14 Quick Assembly Proper orientation of CAM LOCK (x2) (x4) (x2)
- Página 22 STEP 15 Attach the left rail (K) and right rail (L) to the rear rails (J) as shown and then attach front rail (I) to the left and right rails (K&L).
- Página 23 STEP 16 Carefully position unit on its top as shown. Position base rail component from previous step onto bottom (F) so the quickloc fasteners (3) engage the holes and fasten into place. Turn to lock in place.
- Página 24 STEP 17 (x2) (x4) You will use this hinge. Do not use this hinge. Locate the four inset hinges (9). Attach two hinges (9) to the left outer door (M) and right outer door (N) as shown. Press a door bumper (4) onto each door as shown.
- Página 25 STEP 18 (x2) (x4) Attach the remaining hinges (10) and door bumper (4) to the left inner door (O) and right inner door (P) as shown.
- Página 26 STEP 19 Mount doors as shown. Left outer door (M) will attach to the left panel (A). Right outer door (N) will attach to the right panel (B). The left and right inner doors (O&P) will mount to the lower partition (D)
- Página 27 STEP 20 Door Adjustment To adjust the vertical height: Loosen the screws "A" on both hinges. They are usually in slotted holes which allows you to adjust up or down by a few mm. Then tighten back up. To adjust side to side: Loosen the screw "C"...
- Página 28 Maximum Loads This unit has been designed to support the maximum loads shown. Exceeding these load limits could cause sagging, instability, product collapse, and/or serious injury. Apply the TV Warning label to your unit for future reference. NOTICE: Once applied to your model, you will not be able to remove it. Unit holds up to 69"...
- Página 29 Register your product to receive the following: * New trend details - sneak peek on what's new * Surveys - have a voice within our community * Exclusive deals and discount codes * Quick and easy replacement part service To register your product, visit ameriwoodhome.com Visit your local retailer's website, rate your purchased product and leave us some feedback! We would like to extend a big "Thank You"...
- Página 30 Español Cubierta Delantera Este libro de instrucciones contiene información IMPORTANTE de seguridad. Por favor lea y manténgalo para referencia en el futuro. No Regrese este producto! Comuniquese con nuestro amistoso equipo de servicio al cliente para obtener ayuda. Llamenos al: 1-800-489-3351 (Gratis) Lunes - Viernes 9am - 5pm CST Visitar: www.ameriwoodhome.com PRECAUCION Este mueble puede volcarse y causar graves heridas y/o muerte.
- Página 31 Español Página 12 Introduzca a presión cuatro tornillos tipo quick-lock (3) en los huecos en la parte superior (E). Con la corredera superior (H) apoyada horizontalmente con los huecos más grandes (4 huecos) mirando hacia arriba, presione la parte superior (E) contra la corredera superior (H) para que los tornillos tipo quick-lock (3) se ajusten dentro de los huecos.
- Página 32 Español Página 27 Para ajustar la altura vertical: Afloje los tornillos "A" en ambas bisagras. Suelen encontrarse en huecos ranurados, lo que permite subirlos o bajarlos por algunos milímetros. Luego vuelva a ajustarlos. Para ajustar la profundidad: Afloje el tornillo "B" y ajuste la puerta. Para ajustar de lado a lado: Aflojar el tornillo "C"...
- Página 33 Français Couverture Avant CE LIVRET D'INSTRUCTION CONTIENT DES INFORMATIONS IMPORTANTES SUR LA SÉCURITÉ. VEUILLEZ LIRE ET GARDER POUR UNE RÉFÉRENCE FUTURE Ne retournez pas ce produit! Contactez notre équipe de service à la clientèle amicale d'abord pour obtenir de l'aide. Appelez-nous: 1-800-489-3351 (sans frais) du Lundi au Vendredi de 9h à...
- Página 34 Français Page 12 Insérez quatre attaches quickloc (3) dans les trous de la section supérieure (E). Avec la rampe supérieure (H) à plat et les trous les plus grands (4 trous) vers le haut, insérez le dessus du meuble (E) dans la rampe supérieure (H) afin que les attaches quickloc (3) entrent dans les trous.
- Página 35 Français Page 27 Pour ajuster la hauteur verticale: Desserrez les vis « A » sur les deux charnières. Elles se trouvent normalement dans des trous oblongs qui vous permettent d'ajuster la hauteur de quelques millimètres. Resserrez après ajustement. Pour ajuster la profondeur : Desserrez la vis «...