Watts Industries BT-PR02 RF Guía De Usuario página 4

3. Installation
Install and plug the receiver into the following guidelines to guaranty an optimal reception:
- The receiver must be put at a minimum distance of 50cm of all others electrical or wireless materials
like GSM, Wi-Fi router.
- Before wiring work related to the receiver must be carried out only when de-energized
- Connect your receiver to the power supply.
Following your installation an order of pairing must be respected for a correct RF initialisation.
Installation 1: Receiver + RF thermostat
1. The receiver must be put in ON by pressing on the ON/OFF button.
2. The receiver must be put in RF init mode by 5sec pressing on the RF Button.
3. Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode waiting
for a thermostat configuration address.
Please refer to the thermostat leaflet for enter the thermostat in "RF Init" mode.
4.
5. The receiver RF LED must be switched OFF and the thermostat should exit the RF init mode to indicate correct
paring between both elements.
You can pair several receivers to the same RF thermostats
Note for installations 2, 3 and 4: You can pair several receivers. Pay attention! Before to link a new receiver with central
unit, you have to reset imperatively the receiver.
Installation 2: Receiver + RF Thermostat + RF Central unit for heating regulation
1. The RF thermostat must be paired first to the central
2. The receiver must be put one time more in RF init mode by 5sec pressing on the RF Button.
3. Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode waiting
for a central configuration address.
Please refer to the Central leaflet for more explanation about the pairing mode "RF Init". You must pair the
4.
Receiver as an heating device in the central
5. The receiver RF LED must be switched OFF and the Central will show a message to indicate correct pairing
between both elements.
Installation 3: Receiver + RF Central unit for ON/OFF or light control
1. The receiver must be put one time more in RF init mode by 5sec pressing on the RF Button.
2. Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode waiting
for a central configuration address.
Please refer to the Central leaflet for more explanation about the pairing mode "RF Init". You must pair the
3.
Receiver as an ON/OFF plug or a light in the central
4. The receiver RF LED must be switched OFF and the Central will show a message to indicate correct pairing
between both elements.
You can pair several receivers in the same room. Receiver will work in Timer mode, you have the possibility to create a
weekly program for ON/OFF period.
Installation 4: Receiver + RF Central unit for heating regulation. Only valid for the Flush receiver with floor sensor
1. The receiver must be put one time more in RF init mode by 5sec pressing on the RF Button.
2. Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode waiting
for a central configuration address.
Please refer to the Central leaflet for more explanation about the pairing mode "RF Init". You must pair the
3.
Receiver as an heating device in the central
4. The receiver RF LED must be switched OFF and the Central will show a message to indicate correct pairing
between both elements.
Remarks:
- In case of installation with BT- RF thermostat and loss RF communication (RF Alarm), the receiver (BT-PR02 RF,
BT-FR02 RF or BT-WR02 RF) will follow 20% cycle of heating to prevent the installation against frost. (The
receiver will stay in OFF mode if it was in OFF before loss of RF communication).
- Wall receiver H&C: Heating relay should be used for ON/OFF in conjunction with the central unit or for heating
regulation with a thermostat with or without the central unit.
- Plug receiver, Flush receiver, Wall receiver: The leds are switch off between 8pm and 8am when using a BT-
DP02 RF or a central unit
4