Publicidad
Step 14
Step
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as
shown in the left diagram. If it isn't, loosen the adjusting screw and mounting screw to slide it
against the stops. Then tighten the mounting screw.
å
Fasten the DOOR (K) to the TOP (C) as shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before completely tightening any of them.
å
Fasten the PULL (189K) to the DOOR (K). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
å
Adjustments to the DOOR will be made in a later step.
Hinge
Mounting
screw
Stop
Page 20
Adjusting
screw
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
K
C
17
1S
189K
Publicidad
