Alpina CR-38H Manual De Instrucciones página 7

Reversing the door swing of your appliance
This unit has the capability of opening the door either from the left
or the right side. The unit is delivered to you with the door opening
from the left side. Should you desire to reverse the opening direction,
please follow the instructions.
Note: Before reversing the door, the power must be shut off. All parts
removed must be saved for reinstalling the door.
This unit has been built with the door hinges on the right. If you wish to
change the opening direction, follow the instructions below:
1. Remove the upper hinge cover (6) first.
2. Remove the three screws (1) that hold the upper hinge (5) (right
side) to the frame and take away the upper hinge (5) (right side).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the three screws (8) that hold the lower hinge (2) and
make sure to remove the lower hinge (2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the whole cover plate (7) at the right side.
7. Before placing the lower hinge (2), remove the bolt pin (9) and
reverse the direction of the lower hinge (2). Then install the lower
hinge (2) onto the left side of the lower frame with the three screws.
8. Insert the bolt pin into the lower hinge (2).
9. Set the door to its place in the lower hinge (2).
10. While holding the door in the closed position, secure the upper
hinge (5) to the top frame of the left side with the three screws.
Please remember not to tighten the three screws until the top of the
door is leveled with the counter top.
11. Install the upper hinge cover (6) on the upper hinge.
Figure 1.
7
Figure 2.