Kärcher AB 1000 Manual Del Usuario página 9

Description of the Appliance
The scope of delivery of your appliance is illustrated on
the packaging. Check the contents of the appliance for
completeness when unpacking.
In the event of missing accessories or any transport
damage, please contact your dealer.
Note:
Please refer to page 2 for figures of the appliance and
the operation.
1 Ironing table cover
2 Lever for adjusting the height
3 On/ off switch; simultaneously a switch for steam
suction and blower function
4 Socket for steam cleaner
5 Power cord with plug
6 Flexible cable holder
7 Heat-resistant rest for iron
8 Holder for steam cleaner (steam cleaner is not part
of standard delivery)
Specifications
Voltage
Max. connection output of
socket
Ventilation
Weight
Height adjustment
Dimensions, folded
(L x B x H)
For the steam cleaners that are attached to the
holder:
Max. dimensions
(L x B x H)
Max. weight
Your steam cleaner must be approved for operations
in hanging and standing mode.
Start up
Assembling the ironing table
Place the ironing table on firm even ground!
Illustration
 Unwind the mains cable of the ironing table and
slowly move the underframe towards the front. The
ironing table unfolds and can be locked in the de-
sired position. Then lower the ironing table on to
the floor.
Illustration
The height of the ironing table can be adjusted in 7
phases (max. height of 99 cm) and allows you to iron
while standing and sitting.
 To adjust the height, hold the ironing surface with
both the hands, raise the ironing table slightly and
pull up the operating lever with one hand. (Lifting
the ironing table slightly serves as a security func-
tion against accidental switch-on).
The ironing table is locked again only when you
hear it locking in.
59654720_(04-19) - Kopie.pdf 9
Illustration
 Install the flexible cable holder; you can move it to
Illustration
 Insert the power cord of the ironing table in a wall
 Insert the power cord of the steam cleaner into the
 Start-up the steam cleaner according to the de-
Illustration
 Place the iron of the steam cleaner on the rest and
Ironing table and steam cleaner are now ready for
use.
Please note and follow the following instructions to en-
230 - 240 V
sure safe use of the ironing table!
2250 W
Notes:
Please ensure that you always follow the ironing in-
structions stitched on to your clothes along with the in-
21 W
structions and specifications given in the instructions
9,0 kg
handbook of the steam cleaner and the iron!
72 - 99 cm
The blower must always be switched on while ironing
with steam - otherwise there will be condense water for-
165x46x15 cm
mation.
When you shift between ventilator functions (blow out or
suck in), there is short pause due to change in the rota-
tional direction of the blower. Hence, wait for a couple of
360x240x290 mm seconds before continuing.
During breaks in ironing, place the hot iron on the heat-
resistant rest; please remember to first switch off the
9,0 kg
steam function.
Illustration
 Turn the appliance switch to the steam suction po-
Specific use of steam suction:
Shirts, trousers (with crease), pleated skirts, dinner
jackets, tablecloths.
–
–
–
– 5
EN
the left or the right.
Connect the steam generator
socket.
socket at the ironing table. This will ensure power
supply to the steam cleaner.
scription.
clamp in the cable of the iron into the flexible cable
holder.
Ironing
Steam ironing with steam suction
sition.
Fixes the fabric on the table; thus acts against for-
mation of crease.
Causes the steam to penetrate better into the fibre
- this reduces the time taken for ironing and gives
better ironing results.
Ensures a dry ironing table and also helps in drying
the fabric while ironing.
9
28.05.2019 17:44:48