Wesco WS3177 Manual Del Usuario página 13

If your power tool becomes too hot, set the speed to
maximum and run no load for 2-3 minutes to cool the motor.
MAINTENANCE
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the manufacturer or
its service agent.
TROUBLESHOOTING
1 If your drill will not operate, check the power at the
mains plug.
2 If the drill is not cutting properly, check the drill bit for
sharpness, replace drill bit if worn. Check that the drill
is set to forward rotation for normal use.
3 If a fault cannot be rectified return the drill to an
authorized dealer for repair.
EN
13