Publicidad
Idiomas disponibles
Idiomas disponibles
2. FITTING THE CHISEL (See B1, B2)
1). Insert the chisel into the chuck.
2). Drag the stop lever and rotate it to "Lock" position as
shown in Fig. B2.
3. REMOVE THE CHISEL (See B3)
1). Drag the stop lever and rotate it to "Unlock" position as
shown in Fig. B3.
2). Remove the chisel.
4. FITTING THE AUXILIARY HANDLE
(See C,D)
For your personal safety we recommend using the auxiliary
handle at all times.
To adjust the handle, loosen the knob on the auxiliary
handle.
Rotate the handle around the handle to the desired position.
Tighten the knob fully.
5. OPERATING THE ON/OFF SWITCH (See E)
On/off switch
Depress the switch to start the tool and release it to stop
your tool.
Continuous use
Depress on/off switch then lock on button, release on/off
switch first and lock-on button second. Your switch is now
locked on for continuous use. To switch off your tool just
depress and release the on/off switch.
6. CHANGE THE CARBON BRUSH (See F1,
F2)
WARNING! Remove the mains plug from socket
before changing the carbon brushes.
The only user serviceable item on the hammer is the carbon
brush. The spare brush is provided.
Replace the carbon brush as follows:
1) Unscrew the outer brush cover with a Phillips screwdriver.
(See F1)
2) Remove the outer brush cover and unscrew the inner
brush cover with a flat screwdriver. (See F2)
3) If the carbon has worn down to about 6mm it should be
replaced. Always replace the brush at the same time.
4) Insert the new brush and replace the brush cap.
14
WORKING HINTS FOR
YOUR TOOL
Always use sharp good quality chisels. The performance of
the chisel is dependent on the quality of the bits used.
1. Reduce the pressure on the bits when it is about to break
through.
2. Always operate tool using both the handle and the front
handle.
3. Make sure that you wear safety glasses and protective
gloves.
4. Do not apply excessive pressure to the tool. Expressive
force does not speed up the work.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on the
power supply first.
2. If your power tool work efficiency is too low, please add
sufficient grease in the grease box.
3. If your power tool use in low efficiency, please check
whether the chisel is blunt.
EN
Publicidad
