CREE LIGHTING Noctura Serie Instrucciones De Instalación

When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes
and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local. Si vous n'êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
3. Suitable for wet locations.
Convient aux emplacements mouilles
4. Suitable for operation in ambient not exceeding 40°C.
Peut etre utilise a une temperature ambiante n'excedant pas 40°C.
5. Suitable for mounting within 1.2M (4ft) of the ground.
Peut etre installe a moins de 1,2 m (4 pi) du sol.
6. Min. 75°C supply conductors.
Les fils d'alimentation 75°c min.
7. Class 1 wiring only.
Cablage de classe 1 uniquement.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
TO INSTALL:
1
Remove the Two Screws at
these Locations to Allow for
Attachment of Knuckle Mount
Upper Swivel
Knuckle Mount
Remove the Screw
Here to Separate the
Two Halves.
1 of 3
IMPORTANT SAFEGUARDS
Button Photocell
(Ordered Separately)
Attach this Part of the
Knuckle Mount Arm to
Luminaire Head
Lower Swivel
Knuckle Mount
Noctura Series
NTF Luminaires (Small Flood Light)
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
SWIVEL KNUCKLE MOUNT- REQUIRES USE OF
NTF-KN ACCESSORY
STEP 1:
Separate the two halves of the swivel knuckle mount by
removing the screw holding the knuckle together. See
Figure 1.
STEP 2:
Thread the cord coming from the luminaire through the
upper swivel knuckle mount.
STEP 3:
Remove the two screws on either side of the cord grip
on the luminaire housing. Discard screws.
STEP 4:
Attach the upper swivel knuckle mount to luminaire
housing using (2) 1/4-20 screws and lockwashers
provided with the swivel knuckle mount. Tighten screws
to 72 in-lbs ( 8 N·m).
STEP 5:
Thread the cord exiting the upper swivel knuckle mount
through the lower swivel knuckle mount and out of the
nipple at the base of the lower swivel knuckle mount.
STEP 6:
Reassemble the two halves of the swivel knuckle mount
and begin tightening the screw holding the two halves
of the swivel knuckle mount together. Do not fully
tighten screw.
STEP 7:
Pass cord through hole in junction box cover or other
customer supplied mounting and thread nipple into
mount. Use nut on nipple to lock luminaire in position.
LED Flood Lights
LPN00630X0001A0_D