Descargar Imprimir esta página

KYMPO BE260 Manual Del Usuario página 36

Publicidad

The appliance is too noisy
Check that:
- the equipment is level;
- the rear element isn't touching the back wall;
The equipment isn't working at all.
Check that:
- the thermostat isn't set at stop;
- the power supply isn't off;
- the plug is properly in the wall outlet;
- the power cable isn't broken (see the section headed IMPORTANT
SAFETYWARNINGS). If the freezer still won't work properly after carrying out
the procedures described above, call the nearest CUSTOMER SERVICE
(indicated on attached slip).
Impor tant:
the freezer may produce the following slight noises:
When the freezer is installed in a damp, unheated area, droplets of
condensation may form on the external surfaces, especially with relatively low
ambient temperatures and high relative humidity. This phenomenon in no way
affects the equipment's HIÀFLHncy or life cycle.
The manufacturer declines any liability for damage that may directly or
indirectly be caused to persons, proper ty or domestic animals by failure to
observe all the indications in the instruction booklet, and especially the
warnings regarding installation, use and maintenance.
The manufacturer also reserves the right to make any modLÀFations deemed
technically or commercially appropriate at any time and under no obligation to
give prior notice.
14

Publicidad

loading

Productos relacionados para KYMPO BE260

Este manual también es adecuado para:

Bd306Kc05