Work Pro W DimOne MK II Instrucciones De Uso

DimOne
INTRODUCTION
Thanks for purchasing of DimOne
accept standard DMX 512 signal. The slide potentiometer allows to control the output dimmer
value.
It incorporates fixation pieces in order to place it on wall or ceiling. It is very easy to operate.
WARNING
1. THIS DEVICE SHOULD BE SITUATED AWAY FROM HIGH VOLTAGE SOURCES.
2.TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
3. THIS UNIT SHOULD BE CONNECTED TO A POWER SUPPLY ONLY OF THE TYPE DESCRIBED
IN THE OPERATING INSTRUCTIONS OR AS MARKED ON THE DEVICE.
4. PAY PARTICULAR ATTENTION TO THE MAIN POWER SUPPLY VALUE AND SIGNAL POLARITY.
OVERVIEW
1
6
DMX is an universal binary language used as a form of communication between intelligent fixtures. Each Dip
Switch represents a binary value.
Dip Switch 1 address equals 1
Dip Switch 2 address equals 2
Dip Switch 3 address equals 4
Dip Switch 4 address equals 8
Dip Switch 5 address equals 16
Dip Switch 6 address equals 32
Dip Switch 7 address equals 64
Dip Switch 8 address equals 128
Dip Switch 9 address equals 256
DimOne User Manual/Manual de Instrucciones
MK II
OPERATING INSTRUCTIONS
MK II
. DimOne
MK II
5
3 2 4
7 8 9
For example: Setting DMX address for 21.
is a single DMX dimmer. It is able to
MK II
1. FUSE: 10A 250V 5x20 mm.
2. LED POWER: It lits when the unit is supplied.
3. DMX Start Address Dip-Switch: It allows to
select the DMX starting address.
4. DMX LED: It lits when the unit detects DMX
In signal.
5. MASTER CONTROL: This fader controls the dimmer
level of the output channel.
6. POWER IN: Connect to main supply AC 230V
50 Hz.
7. LOAD: Connect it a load up to 10 A.
8. DMX IN: It accepts standard DMX 512 signal
Connect it according to the upper table.
Note: 9V DC pin allows to supply the optional
ControlOne (sold separately).
9. DMX THRU: It allows to send DMX signal to another
device.
Flip switches1,3,&5 to the
"ON"position
1=1
3=4
Dipswitches# 5=16
=21
Pag 1
Value
EN