Resumen de contenidos para Dorel Home Products DA4063019
Página 1
You can also chat with us at www.dhpfurniture.com Date of Purchase Lot Number (TAKEN FROM CARTON) THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. C.W. - 2021/2/2 B34DA406301900-241637-C 2020 Dorel Home Products All Rights Reserved...
Página 2
Limited 1 year Warranty Read Before Beginning Assembly Dorel warrants this product to be free from defects in material and workmanship Work in a spacious area and near where the unit will be used, preferably on a and agrees to remedy any such defect. This warranty covers one year from the carpet, or use a piece of the cardboard packaging to protect your floor and product.
Página 3
WARNINGS This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules.
Página 5
PARTS LIST Post Fabric Back Panel Post Headboard Side Panel 1 PC 1 PC 1 PC 2 PCS 1 PC Footboard Side Panel Side Rail Side Rail Center Rail 1 PC 2 PCS 2 PCS 2 PCS 4 PCS Bracket Brace Cross Brace 2 PCS...
Página 6
PARTS LIST Bracket Wooden Slats Single Slat Cap Double Slat Cap 2 PCS 24 PCS 1 PC 24 PCS 12 PCS Adapter 1 PC PART NUMBERS DA4063019 DA4063019 Part Part (Dark Gray) (Dark Gray) Labels Labels T1002970 T926720 T1002980 T938080 T1002990...
Página 7
Hardware Pack Please do not completely tighten all the hardware, until the entire assembly is complete, unless otherwise indicated in the step-by-step instructions. DA4063019 HP#: TDA4063019-00 The screw(s), bolt(s) to be used at each step are Wrench shown in actual size in the lower right corner of the 1 PC page.
Página 8
Step 1 Attach brace N to post A & B with bolts NOTE Do not fully tighten the bolts, Loose bolts will facilitate assembly in the following steps. NOTE: Holes on post A, B & brace N must be oriented towards the same direction.
Página 9
Step 2 Note: Slat holes on G Attach side rail G x 2 & F to side panel D & and F must be on top. E with bolts , as illustrated; Repeat the same step for the remaining side rail G & F and side panel D & E. X 20...
Página 10
Step 3 3.1 Attach bracket M x 2 to side panel D & E with bolts 3.2 Attach leg J to side panel D & E with washer , bolts Repeat the same step for the other subassembly D and E. NOTE Do not fully tighten the bolts, Loose bolts will facilitate assembly in the...
Página 11
Step 4 Attach leg Q x 2 to footboard H with Note: Orient leg Q as indicated with the slope opposing each other.
Página 12
Step 5 Attach subassembly from previous STEP to post A, B & footboard H with washer bolts NOTE Do not fully tighten Hint: The slot of bracket M the bolts, Loose bolts will must rest on bolt and the facilitate assembly in the following steps.
Página 13
Step 6 Attach leg L to center rail I with bolts washer...
Página 14
Step 7 Attach center rail I x 2 to brace N and footboard H with bolts NOTE Do not fully tighten the bolts, Loose bolts will facilitate assembly in the following steps.
Página 15
Step 8 Attach cross brace K to side rail F x 2 with bolts , nuts Attach leg L to center rail I x 2 with bolts and nuts through bracket Z and cross brace K. NOTE Do not fully tighten the bolts, Loose bolts will facilitate assembly in the following steps.
Página 16
Step 9 Stick C1 to the back of headboard C with Velcro as illustrated. Please align the holes with the ones on headboard. To avoid fraying the fabric during the assembly, please lay the Headboard (C) on a Piece of carboard.
Página 17
Step 10 OPTION 1 (Lowest): This headboard offers you two options for height. Attach post A & B to headboard C with washer and bolts Tighten all bolts previously installed in step 1~8. OPTION 2 (Highest):...
Página 18
Step 11 11.1 Insert O into X ; 11.2 Press X into F and G, repeat the same procedure for the opposite side with a new and X . 11.3 Insert ends of both slats O into Y , then press Y into I as illustrated. 11.1 11.2 11.3...
Página 19
Step 12 Plug cable from headboard C to adapter S.
Página 20
CAUTION: This unit is intended for use only with the products and/or maximum Helpful Hints weights indicated. Use with other products and/or products heavier than the maximum weights indicated may result in instability or cause possible injury. Move your new furniture carefully, with two people lifting and carrying the unit to its new location.
Página 21
DA4063019(Gris oscuro) NO LO REGRESE A LA TIENDA! Si le faltan piezas o las que se incluyen est n da adas, con mucho gusto le enviaremos sus piezas de reemplazo sin cargo extra. Cama tapizada con USB Visite www.dhpfurniture.com/spa/replacement-parts Individual...
Página 22
Partes Paquete de componentes # de Paquete :DA4063019: TDA4063019-00 Piezas de reemplazo, visite www.dhpfurniture.com/spa/replacement-parts IMPORTANTE: La lista de n meros de piezas que aparece a continuaci n es Nota: Por favor no apriete completamente los pernos hasta que el exclusiva de su producto. Por favor, mant ngalo a mano cuando solicite piezas ensamblaje sea completado, a menos de que se indique espec ficamente en de repuesto.
Página 23
Instrucciones Paso 1 Paso 12 Enchufe el cable de C a S. Una N con A & B con Paso 2 Una G X 2 & F con D & E con , a como se muestra; Repita el paso para las otras partes G & F y D & E. L mites de peso: 250 Lb / 113 Kg Paso 3 3.1 Una M X 2 con D &...
Página 24
PRECAUCI N Este dispositivo cumple con la parte 15 de las Reglas de la FCC. El funcionamiento est sujeto a las siguientes dos condiciones: (1) este dispositivo no puede causar interferencias perjudiciales y (2) este dispositivo debe aceptar cualquier interferencia recibida, incluidas las interferencias que puedan causar un funcionamiento no deseado. Nota: Se han realizado pruebas en este equipo y se ha comprobado que cumple con los l mites establecidos para los dispositivos digitales de Clase B, de acuerdo con la Parte 15 de la normativa de la FCC.
Página 25
DA4063019(Gris fonc ) NE PAS RETOURNER CE PRODUIT AU MAGASIN ! Si une pi ce est manquante ou endommag e, nous vous exp dierons avec plaisir vos pi ces de remplacement gratuitement. Lit rembourr avec USB Visitez www.dhpfurniture.com/fre/replacement-parts ou appelez au 1-800-267-1739...
Página 26
Pi ces Quincaillerie Pour des pi ces de rechange, visitez www.dhpfurniture.com/fre/replacement-parts # de paquet : DA4063019: TDA4063019-00 IMPORTANT: La liste des r f rences ci-dessous est propre votre produit. Veuillez l'avoir sous la main lorsque vous appelez pour des pi ces de rechange.
Página 27
Instructions tape 1 tape 12 Branchez le c ble de C Attacher N A & B avec tape 2 Attacher G x 2 & F D & E avec , comme illustr . R p tez la m me tape pour les autres G, F et D & E. tape 3 3.1 Attacher M X 2 D &...
Página 28
AVERTISSEMENT Cet appareil est conforme la section 15 de la r glementation de la FCC. Son fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d interf rences nuisibles et (2) cet appareil doit accepter toutes les interf rences re ues, y compris celles pouvant entra ner un fonctionnement non souhait . Note: Cet quipement a t test et d clar conforme aux limites pour appareils num riques de classe B, selon la section 15 des r glements de la FCC.