Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 6
1. Glass
2. Silicon Seal
3. Tray
4. Connection Element
2.2.2.
Installation of the range
The range is equipped with a seal to prevent the liquids through the cavities into
the cabinet. In order to place this seal, adhere the seal as shown in the figures
above. Turn the range upside down and remove the protective tape of the rubber
seal and adhere it to the range; both ends of the seal should meet each other.
Install the mounting sheets as shown in figure 5 by help of screw. And place the
range in the opening on the counter.
Figure 7 shows the size to which the counter will be cut for installation of the
range. Place the prepared range into the counter cut to these sizes. If you will
use the range on the built-in oven, observe the figures 9 and 10 for proper air
circulation between the oven and range
Start to use after you remove the protective film on Inox surface.
1
2
3
4
.
Figure 8
5
6
7
8
9
5. Upper Tray
6.Silicon Seal
7.Counter Surface
8.Connection Clips
9.Screw
Figura 7
9
Figure
EN
8
Publicidad
