Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation for Use
1. Remove all packing from the kettle and its power base.
Before using the kettle for the first time, r if it has been
out of use for a long time fill to the max mark and boil,
then discard the boiled water and rinse the kettle out
with cold water.
2. Before connecting the appliance to the mains supply
check that the voltage indicated on the rating plate
corresponds with the mains voltage in your home.
Instructions for Use
1. Always remove the kettle from the power base before
filling.
2. Lift the lid.
3. Fill the kettle between the MIN and MAX marks on the
water level indicator with cold water.
4. Replace the lid and place the kettle back on the power
base. Make sure the lid is securely fitted on the kettle
before boiling.
5. Position the kettle on the power base.
6. Plug the power base into the power outlet and switch
on at the mains.
7. To start boiling press the ON/OFF switch to the down
position.
8. The power indicator will illuminate and the kettle will
start to boil. NEVER REMOVE THE LID DURING BOILING.
9. When the water has boiled the kettle will switch off
automatically and the power indicator will extinguish.
10. You can stop the boiling process at any time by
pressing the switch to the OFF position.
11. After the kettle has switched off automatically, there
may be a short delay before it can be re-boiled. This is
usually no more than 20 seconds.
Overheating safeguard
The jug kettle is fitted with an overheating safeguard.
This will switch off the jug kettle if it is operated without
(sufficient) water. Allow the jug kettle to cool down for at
least 15 minutes before using it again.
Cleaning and maintenance
1. Always unplug the kettle from the mains supply and
allow to cool down completely before storing or cleaning.
2. Never immerse any part of the power cable, plug,
power base or kettle in water or any other liquid.
3. Wipe the exterior of the kettle using a damp cloth.
Dry thoroughly. Never use harsh chemicals or abrasive
cleaning agents as these may damage the finish of your
kettle.
ATTENTION
• Never use corrosive or scouring cleaning agents or
sharp objects (such as knives or hard brushes) to clean
the appliance.
• Before cleaning, make sure that the appliance is not
connected to the power supply and that it has cooled
down.
Safety, as insertion into a 13 amp socket could cause
an electrical hazard.
Descaling
Over a period of time lime scale can build up inside your
kettle. To remove lime scale half fill the kettle with water
and add the juice of a lemon. Boil the kettle and allow to
stand for 15 minutes before discarding. Repeat several
times using cold water only.
TECHNICAL DATA
Rated Voltage: AC 220-240V ~ 50/60Hz
Power: 1850-2150W
Capacity: 1.8L
Publicidad
