URSUS TROTTER UT-KERAMIKTOP Manual De Instrucciones página 7

3.If only set thermostat knob to MAX position
as per the temperature indicator, steam iron will
be available, otherwise water may leak from the
soleplate.
4. It indicates that the temperature has been ready
until the indicator light goes off.
5. Set the steam selector correctly, increase steam
output by pushing the steam selector back and
decrease steam output by forward.
Caution: Synthetic Fabric, Nylon, Synthetic Silk and
Silk cannot use the steam iron, otherwise it will
damage the finish of surface.
Burst of Steam:
This function works well for tough wrinkles and
heavy fabrics. By pressing "Burst of Steam" button,an
intense burst of steam is emitted from the soleplate,
this can be very useful when removing stubborn
creases. The shot of steam facility can be used
only while ironing with high ironing temperature.
For optimal result, there should be 5 seconds rest
between presses of the steam button. To prevent
leaking water from the soleplate does not press the
steam button continuously for more than 5 seconds..
Also allow at least one minute interval before
applying this burst of steam function.
Spraying Methods:
At any temperature by pressing the spray button a
couple of times, the laundry can be damped down.
Ensure that there is enough water in the water tank.
Self-Cleaning:
Use the self-cleaning function once every two weeks.
If the water in your area is very hard(i.e, when flakes
come out of the soleplate during ironing),the self-
cleaning function should be used more frequently.).
Make sure the appliance is unplugged, set the steam
selector to position "O", fill the water tank to the
MAX position, do not put vinegar or other dealing
agents in the water tank., select the maximum
ironing temperature, put the plug in the wall socket,
unplug the iron when the power indicator lighter has
gone out, hold the iron over the sink, press and hold
the self-cleaning button and gently shake the iron to
and fro. Steam and boiling water will come out of the
soleplate, impurities and flakes(if any),will be flushed
out. Release the self-cleaning button as soon as all
the water in the tank has been used up. Repeat the
self-cleaning process if the iron still contains a lot of
impurities. After the self-cleaning process, put the
plug in the wall socket and let the iron heat up to
allow the soleplate to dry, unplug the iron when it has
reached the set ironing temperature, move the hot
iron gently over a piece of used cloth to remove any
water stains that may have formed on the soleplate,
let the iron cool down before you store it.