Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING
INSTRUCTIONS section of this manual to alert you to potential
personal injury hazards . Obey all instructions to avoid possible
injury .
The load leveler is designed to be used with a portable shop crane to
handle and position engines and other large vehicle components . The
drive screw adjusts the sling's lift point in relation to the mounting chains
to compensate for off-center loads, or adjusts to a certain angle for
component removal or installation .
1 . Attach the shop crane's hook or attachment device to the oval link
at the top of the sling's lifting block . Make sure the connection is
secure .
2 . Lift only on the areas of the engine or component as specified by
the vehicle manufacturer . Make sure that all four chains are securely
fastened to the load .
3 . Before lifting make sure that all fuel and electrical lines and
components are clear of the load .
4 . Lift the load just high enough to locate the center of balance or the
desired angle in which the load can be removed . This adjustment
is accomplished by turning the sling's drive screw in a clockwise or
counterclockwise rotation .
PREVENTATIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE
MAINTENANCE section of this manual to alert you to potential
personal injury hazards . Obey all instructions to avoid possible
injury .
IMPORTANT: Any leveler found to be defective as a result
of worn parts due to lack of lubrication is not eligible for
warranty consideration .
1 . Always store the leveler in a well protected area where it will not be
exposed to inclement weather, corrosive vapors, abrasive dust, or any
other harmful elements .
2 . The leveler must be lubricated periodically in order to prevent
premature wearing of parts . A general purpose grease must be
applied to the threads on the screw .
3 . Every sling owner is responsible for keeping its label clean and
readable .
4 . Do not attempt to make any repairs unless you are a qualified repair
person that is familiar with this equipment .
MTN5116A 02/02/12
Operating Instructions • Preventative Maintenance
Limited Warranty...
MOUNTAIN™ BRANDED PRODUCTS ARE
WARRANTED AGAINST DEFECTS IN WORKMANSHIP
AND MATERIALS FOR A PERIOD OF ONE YEAR
FROM DATE OF ORIGINAL PURCHASE.
Any Mountain™ branded product which fails to give satisfactory service
due to defective workmanship or materials will be repaired or replaced
at our option during the warranty period .
Other important warranty information...
This warranty does not cover damage to equipment or tools arising
from alteration, abuse, misuse, damage and does not cover any repairs
or alterations made by an unauthorized service center .
The foregoing obligation is our sole liability under this or any implied
warranty and under no circumstances shall we be liable for any
incidental or consequential damages .
Note: Some states do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation or exclusion may not
apply to you .
This warranty gives you specific legal rights and you may also have
other rights which vary from state to state .
CONTACT INFORMATION:
Please contact the dealer/distributor where the item was purchased . Be
certain to include with any returned products your name and address,
evidence of the purchase date, and description of the suspected defect .
- 3 -
Publicidad
