Publicidad
Idiomas disponibles
Idiomas disponibles
3.2 DETERGENT DISPENSER
(Optional) (Fig. 7)
The machine is equipped with an automatic detergent
dispenser.
•
Insert the red supply tube (9) into the canister 10).
ATTENTION
Always wash the hands under running water if they
come into contact with detergent, or comply with the
specific indications pertaining to the utilized type of
detergent itself.
•
Proceed with a few no-load cycles until the intake
and delivery tubes have filled.
To adjust the dispenser, refer to the relative enclosed
manual and to the utilized type of detergent.
3.3 FILLING THE RINSING AGENT
DISPENSER (Fig. 7)
•
Insert the transparent tube (11) into the canister (12)
containing rinsing agent.
•
Start the machine as described in paragraph 2.1.
The dispenser will suck about 3 cm of liquid from
the canister.
•
Fill during the cycle by opening (slightly) and closing
the hood until the tube has completely filled.
3.3.a Adjusting the dose
•
Start the machine as described in paragraph 2.1 and
hold a glass up to the light at the end of the cycle.
•
The drops of water on the glass will indicate insuffi-
cient dosage while streaks will indicate that dosage
is excessive either in relation to density or quantity.
•
Regulate by means of the plug, turning clockwise to
decrease the quantity or anticlockwise to increase
it.
IMPORTANT
These data are indicative and not binding since they
may vary according to the hardness of the water or the
utilized type of detergent and rinsing agent.
ATTENTION
If the utilized product (detergent or rinsing agent) is
changed, it is advisable to flush out the dosing system
with water and to then proceed by filling the dispensers.
EN
37
Publicidad
