Natural Cycles 54-359BSL Instrucciones

Digital Basal Thermometer
Model 54-359BSL
THANK YOU FOR PURCHASING A BASAL DIGITAL THERMOMETER. PLEASE READ THESE INSTRUCTIONS
CAREFULLY TO ENSURE PROPER USE AND SAFE OPERATION OF YOUR THERMOMETER.
Probe
Digital Battery
Tip POWER
Display Button Compartment
PLEASE READ AND SAVE THESE INSTRUCTIONS
• This product is not intended to diagnose or treat any health problem or disease and should not be
used as a substitute for the consultation and advice of a physician or other medical professional.
• Thermometers should only be used under the supervision of an adult.
• This thermometer should be held during use; the patient should be seated or lying down during
readings.
• Before use, it is recommended that the patient avoid eating, drinking, smoking or exercising for at
least twenty minutes prior to taking a measurement. Never walk, run or talk during a measurement.
ABOUT BASAL BODY TEMPERATURE
Normal oral temperature readings vary throughout the day. Level of activity, time of day, beverages,
smoking and other factors may affect body temperature.
Basal body temperature is the lowest temperature reached during sleep. Basal temperature is measured
immediately after a full night's sleep, before moving, talking, drinking, getting out of bed, or any other
activity. It is best taken immediately upon awakening, but before reaching full consciousness – while
you are still half asleep. The reading should be taken at the same time each morning upon waking, and
you should note other factors that may alter your temperature, such as sleep disturbances, alcohol use,
illness, traveling, toothache, sunburn,medications, or the use of an electric blanket.
As basal temperature is charted over the course of weeks and months, patterns will be revealed that
can be used to determine when in your menstrual cycle ovulation occurs, which in turn indicates in
which days of your cycle that conception may occur. This pattern can help you to either achieve or avoid
pregnancy.
The typically acknowledged normal temperature of a healthy person is 98.60° F (37.00° C). In the
beginning of a menstrual cycle (which starts at the beginning of a period), the basal oral temperature
can range from 96.50° F to 98.00° F (35.80° C – 36.70° C). In the last two weeks of the menstrual
cycle, the basal temperature typically increases by about 0.50° F (0.30° C). The shift in basal body
temperature occurs at about the time of ovulation, during which conception occurs.
By charting basal body temperature throughout the menstrual cycle, a determination can be made as to
when ovulation is occurring, based on the increase in basal temperature. Ovulation occurs only once per
cycle, and intercourse at or near the time of ovulation may result in conception.
WARNINGS AND CAUTIONS
Please note that this thermometer is not intended for use as a contraceptive. Many factors may influence
body temperature; therefore, we can make no claims regarding the reliability of results in predicting ovula-
tion. Consult a healthcare professional for advice regarding contraception and family planning.
FAHRENHEIT CELSIUS SWITCHABLE FEATURE
This unit takes measurements in both Fahrenheit and Celsius. While the unit is OFF, press and hold the
POWER button. After the brief self-test, the unit will show the last reading in either °F or °C. Continue to
hold the POWER button, and display will change the mode and display the new temperature reading mode.
Release the POWER button and begin your reading.
MEMORY RECALL
This unit includes a recall of the last measurement taken. When the unit is OFF, press the
POWER button to turn the unit on, and release. After the self-test, the unit will briefly
show the last reading with an 'M' on the display.
OPERATING INSTRUCTIONS
Temperature should be taken immediately upon waking, at the same time each morning,
and before getting out of bed, moving, talking, drinking, or performing any other activity.
Ideally, the patient should still be half-asleep during the reading.
Press and release the POWER button to activate the thermometer. The unit will beep
and the display will show all of the digital display symbols as it performs a self-test before
showing the last reading in memory.
A Lo with a flashing °F will appear in the display, followed by a brief flash of the last reading in memory; the
display will return to the flashing Lo, indicating that the thermometer is ready for measurement.
ORAL USE
1. Apply a probe cover if using; apply the probe cover before pressing the POW-
HEAT HEAT
ER button.
POCKET POCKET
2. Place the probe under the tongue as near as possible to a heat pocket as noted
in the diagram. Readings will be progressively lower the further the probe is
from the indicated heat pockets.
3. Hold the thermometer in place during the reading; do not bite down on the
thermometer. The mouth must remain closed to ensure accurate results. The reading should take
approximately 60-seconds.
4. When the reading is complete and the peak temperature has been reached, the °F(°C) will cease
flashing.
5. If the reading below 100.0°F(37.8°C), the unit will sound ten long beeps. If the reading is at or above
100.0°F(37.8°C), the unit will sound ten sets of three short beeps.
To turn the unit off, simply press the POWER button. The unit will automatically shut-off after
6.
approximately ten minutes.
7. Record your readings to help track your ovulation.
PROBE COVER USE
Disposable, hygienic probe covers are recommended for use with stick thermometers to prevent contam-
ination. Probe covers are intended for one-time use only; a new probe cover should be used with each
application. Probe covers can commonly be found at your local retailer or can be ordered direct by using the
attached order form.
CARE AND CLEANING INSTRUCTIONS
Store the unit in the provided protective case when not in use. Do not store the thermometer where it will be
exposed to direct sunlight, dust or humidity. Avoid extreme temperatures. Do not attempt to disassemble the
unit. If ERR displays and no measurement can be obtained, the unit must be replaced.
Clean the thermometer by wiping with rubbing alcohol (70% isopropyl alcohol) or soap and water. Do not
submerge in any liquid or autoclave. Wipe the thermometer with a dry cloth and allow to air dry.
REPLACING THE BATTERY
This thermometer includes 1 LR41 alkaline or SR41 silver oxide battery. If the
battery is low or expired, the battery symbol will appear on the display; replace
the battery as soon as possible.
1. Remove the battery cap by pulling gently.
2. Looking at the unit from the back side (ratings label face up) carefully
slide the battery tray out so the entire battery is exposed.
3. Remove the battery with a non-metal tool. Do not attempt to remove the
thin plastic battery cover bar.
4. Replace the battery with a LR41 alkaline or SR41 silver oxide type
battery with the positive (+) side facing up.
+
5. Carefully replace the battery cap.
6. Do not dispose of used batteries in the trash. Consult your local recycling center for the proper way
to dispose of batteries in your area. Keep used batteries away from children, pets and excessive
heat.
TROUBLESHOOTING / ERROR CODES
Performance may be degraded should one or more of the following occur:
• Operation outside stated temperature and humidity range
• Storage outside state temperature and humidity range
• Mechanical shock
• Patient temperature is below ambient temperature
Error Problem/Cause Solution
Hi °F(°C) The measured temperature is at/ Results are above range; wait several minutes and attempt
above 110.00°F (43.00°C) new measurement.
The measured temperature is Results are below range; wait several minutes and attempt
Lo °F(°C)
below 90.08°F (32.00°C) new measurement.
Unit malfunctioned Attempt new measurement; if error persists contact
Err
Customer Care.
Replace with a new battery.
Battery depleted; battery icon
flashing
PRODUCT SPECIFICATIONS
Specifications are subject to change without notice
BATTERY: One 1.5V button size battery LR41 or equivalent
BATTERY LIFE: Approximately 20 months;
AUTOMATIC SHUT-OFF: Approximately after 10 minutes of non-use
MEASUREMENT RANGE: 90.0°F – 109.9°F (32°C – 42.9°C)
ACCURACY: ±0.1°F, 96.80°F - 102.2°F (±0.05°C, 36.0°C - 39.0°C )
Outside of this range: ±0.2°F (±0.10°C)
OPERATING TEMPERATURE: 50.0°F – 104.0°F (10°C – 40°C)
STORAGE TEMPERATURE: 14.0°F – 140.0°F (-10°C – 60°C)
DISPLAY: Liquid crystal display
DISPLAY RESOLUTION: 5 digits (1/100 th of a degree increments)
DIMENSIONS: 5-1/2" X 7/8" X 3/8"
WEIGHT: 0.38 ounces
STANDARD: Meets ASTM Standard E 1112
Toll-Free Customer Care Help Line: 1-866-326-1313
Monday – Friday 8:30 a.m. – 4:30 p.m. CST
FCC STATEMENT
IMPORTANT INFORMATION REQUIRED BY THE FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference; and (2) this device must accept any interference received,
including interference that may cause undesirable operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency en-
ergy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
ONE-YEAR WARRANTY
Congratulations on your purchase of a Digital Thermometer. Your Thermometer is covered by the following
limited warranty commencing upon the date of purchase, and subject to the following terms and conditions:
The Warrantor warrants that its Thermometer will be free from defects in materials and workmanship under
normal consumer usage for a period of one year for the original purchaser of the Thermometer.
Periodic maintenance, repair and replacement of parts due to normal wear and tear are excluded from cover-
age. Defects or damage that result from: (a) improper operation, storage, misuse or abuse, accident or neglect,
such as physical damage (cracks, scratches, etc.) to the surface of the product resulting from misuse; (b) con-
tact with liquid, water, rain, extreme humidity or heavy perspiration, sand, dirt or the like, extreme heat, or food;
(c) use of the Thermometer for commercial purposes or subjecting the Thermometer to abnormal usage or
conditions; or (d) other acts which are not the fault of the Warrantor, are excluded from coverage. This warranty
does not cover batteries or other power sources that may be provided with, or used with the Thermometer.
If the Digital Thermometer fails to conform to this limited warranty, return the Thermometer to: Attn: Repair
Department, 1175 Lakeside Drive, Gurnee, IL, 60031. When returning a product, please also include: (i) a copy
of your receipt, bill of sale or other comparable proof of purchase; (ii) a written description of the problem; and (iii)
your name, address and telephone number. Carefully package the product to avoid any damage that may occur
while in transit; shipping insurance with returned receipt is recommended. At our option, the warrantor will repair
or replace the unit found to be defective in materials or workmanship under normal consumer usage. The purchas-
er will be notified of any additional repairs required prior to completing the repair, and will be responsible for parts
charges, if any, and repair charges not covered by this limited warranty.
EXCEPT AS PROVIDED FOR IN THIS LIMITED WARRANTY, ALL EXPRESS AND IMPLIED WARRANTIES AND
CONDITIONS ARE DISCLAIMED, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANT-
ABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE REPAIR OR REPLACEMENT AS PROVIDED UNDER
THIS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER, AND IS PROVIDED IN LIEU OF ALL
OTHER WARRANTIES, EXPRESS OR IMPLIED. IN NO EVENT SHALL THE WARRANTOR BE LIABLE, WHETHER IN
CONTRACT OR TORT (INCLUDING NEGLIGENCE) FOR DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE
PRODUCT, OR FOR ANY INDIRECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES OF ANY KIND, OR FOR
DAMAGES TO, OR LOSS OF, OTHER PROPERTY OR EQUIPMENT OR PERSONAL INJURIES TO THE FULL EXTENT
THESE DAMAGES MAY BE DISCLAIMED BY LAW.
Some states and jurisdictions do not allow the limitation or exclusion of incidental or consequential damages,
or limitation on the length of an implied warranty, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from state to state or
from one jurisdiction to another.