Publicidad
Idiomas disponibles
Idiomas disponibles
Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety
information carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Package contents (Fig. A)
1 x backrest (1)
1 x seat (2)
1 x 5-star base (3)
1 x armrest, right (4)
1 x armrest, left (5)
1 x plate (6)
5 x castor (7)
1 x gas spring (8)
1 x gas spring cover, 3-part (9)
2 x armrest cap (10)
6 x screw, short (11)
8 x screw, long (12)
1 x allen key (13)
1 x assembly instructions
Technical data
Only suitable for carpeted floors
Maximum load: 110kg
110
Date of manufacture (month/year):
05/2022
Intended use
The item is not intended for commercial use. This
item has been developed for private indoor use.
Safety information
Life-threatening hazard!
• Never leave children unsupervised with the
packaging materials. There is a risk of suffoca-
tion.
Risk of injury!
• Make sure the item is stabilised before use.
• Place the item on a level surface.
• The item may only be used under adult super-
vision, and should not be used as a toy.
• The item is not a toy or a climbing apparatus!
Ensure that persons, especially children, do
not pull themselves up on the item or lean
against it. The item can tip over.
• Check the item for damage or wear before
each use. Use the item only if it is in perfect
condition!
• Ensure that the item has been assembled prop-
erly and in accordance with these assembly
instructions. Improper assembly can lead
to injuries and impair the item's safety and
functionality.
• The gas spring may only be replaced or
repaired by a trained professional.
• Never stand on the item.
Assembly
Note: enquire at a specialist store about the
suitable castors for your flooring.
1. Insert the castors (7) into each castor
guide (3a) in the 5-star base (3) (Fig. B).
2. Next insert the gas spring (8) into the base (3)
and then place the gas spring cover (9) over
the gas spring (8) (Fig. C).
3. Screw the plate (6) onto the underside of the
seat (2) with the short screws (11) (Fig. D).
Note: pay attention to the correct alignment of
the plate.
4. Screw the right armrest (4) and the left
armrest (5) onto the seat (2) with the long
screws 12) and attach the armrest cap (10)
(Fig. E).
5. Screw the backrest (1) onto the seat (2) with
the screws (11) and (12) (Fig. F).
Note: screw the screws in loosely at first, and
tighten them completely once the item is com-
pletely assembled.
6. Insert the gas spring (8) into the plate (6)
(Fig. G). Put the assembled item under strain
to tightly connect the parts together.
GB/IE
11
Publicidad
